ZSE40-T1-62 SMC Corporation of America, ZSE40-T1-62 Datasheet - Page 4

• Manufacturer Part Number: ZSE40-T1-62
• Description: SENSOR VACUUM 101.3KPA PNP/ ANLG
• Manufacturer: SMC Corporation of America
• Series: ZSE40r

Specifications of ZSE40-T1-62

• Pressure Type: Vacuum
• Operating Pressure: -14.65 ~ 1.45 PSI, -101 ~ +10 kPa
• Port Size: Female, 1/8" (3.175mm) NPT
• Output: Digital
• Voltage - Supply: 12 V ~ 24 V
• Termination Style: Cable with Connector
• Operating Temperature: 0°C ~ 50°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 606-1011

Calibration Procedures
Initial Setting
Manual Pressure Setting
Output mode differs by the pressure set value.
16-2-20
Series
Press the
ZSE40/ISE40
SET
“SET”
Unit mode: When using a product with
1. Manual set mode
button.
1. Initial condition mode
Press the “SET” button for more
than 2 seconds until “
displayed.
Release it when the display turns
to “
4. Input set point value for OUT2 (1)
Select the manual set mode in
the initial condition mode and
press the “SET” button until
“
Displays the set values
“
button: Increases set value
button: Decreases set value
”
”
”.
or
alternately.
“
a unit switching function,
refer to the next page for
unit-setting (for overseas).
”
is displayed.
“
” is
Press the
Press the
”
or
SET
SET
“SET”
“SET”
button.
5. Input set point value for OUT2 (2)
button.
4. Selection of response time
2. Input set point value for OUT1 (1)
2. Selection of output mode OUT1
Displays the set values
“
Displays the set values
“
Select the “output mode” for
OUT1 by pressing either
ton or
“
“
Select the response time by
pressing either
button.
(“
“
Select among them.)
button: Increases set value
button: Decreases set value
button: Increases set value
button: Decreases set value
”
”
” Normally open mode
” Normally closed mode
”: 2.5 ms, “
”: 192 ms,“
alternately.
alternately.
button.
button or
”: 24 ms,
”: 768 ms
“
“
Press the
Press the
”
”
Press the
Press the
or
or
but-
SET
SET
SET
SET
“SET”
“SET”
“SET”
“SET”
button.
button.
3. Input set point value for OUT1 (2)
5. Setting Auto/Manual
6. Display of setting auto shift
button.
3. Selection of output mode OUT2
Displays the set values
“
∗
button.
Select the “output mode” for
OUT2 by pressing either
button or
“
“
Only for ZSE40(F)/ISE40-„-30/70(L)-M,
displays the input mode “
compensation value alternately.
If auto shift input is not complete, zero
is displayed.
Select “Auto preset mode” or
“Manual set mode” by pressing
either
“
“
button: Increases set value
button: Decreases set value
”
” Normally open mode
” Normally closed mode
alternately.
” Auto preset mode
” Manual set mode
button or
button.
“
button.
” and the
”
Press the “SET” button
to complete the setting.
Press the “SET” button
to complete the setting.
or
SET
SET