STGIPS10K60A STMicroelectronics, STGIPS10K60A Datasheet - Page 13

• Manufacturer Part Number: STGIPS10K60A
• Description: MOD IPM 600V 10A 25-SDIP
• Manufacturer: STMicroelectronics
• Type: IGBTr

Specifications of STGIPS10K60A

• Configuration: 3 Phase
• Current: 10A
• Voltage: 600V
• Voltage - Isolation: 2500VDC
• Package / Case: PCB Module
• Module Configuration: 3-Phase Bridge
• Transistor Polarity: N Channel
• Dc Collector Current: 10A
• Collector Emitter Voltage Vces: 600V
• Power Dissipation Pd: 33W
• Operating Temperature Range: -40°C To
• Rohs Compliant: Yes
• Collector-emitter Saturation Voltage: 2.1 V
• Continuous Collector Current At 25 C: 10 A
• Power Dissipation: 26 W
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: Through Hole
• Operating Temperature (max): 125C
• Operating Temperature (min): -40C
• Pin Count: 25
• Mounting: Through Hole
• Screening Level: Automotive
• For Use With: 497-10836 - POWER BOARD STGIPS10K60A
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-10404-5

STGIPS10K60A
4.1
Recommendations
●
●
●
●
●
●
Table 12.
Symbol
f
t
V
V
V
PWM
dead
CC
PN
BS
Input signal HIN,LIN are active-high logic. A 500 kΩ (typ.) pull down resistor is built-in
for each high side input. If an external RC filter is used, for noise immunity, pay
attention to the variation of the input signal level.
To prevent the input signals oscillation, the wiring of each input should be as short as
possible.
By integrating an application specific type HVIC inside the module, direct coupling to
MCU terminals without any opto-coupler is possible.
Each capacitor should be located as nearby the pins of IPM as possible.
Low inductance shunt resistors should be used for phase leg current sensing.
Electrolytic bus capacitors should be mounted as close to the module bus terminals as
possible. Additional high frequency ceramic capacitor mounted close to the module
pins will further improve performance.
Control supply voltage Applied between V
High side bias voltage
prevent Arm-short
PWM input signal
Recommended operating conditions
Blanking time to
Supply Voltage
Parameter
Doc ID 15587 Rev 7
Applied between P-Nu, Nv, Nw
Applied between V
i = U, V, W
For each input signal
-40°C < T
-40°C < T
c
j
< 125°C
< 100°C
Conditions
CC
BOOTi
-GND
-OUT
i
for
Applications information
Min.
13.5
13
1
Value
Typ.
300
15
Max.
400
16
16
20
Unit
13/18
kHz
µs
V
V
V