DC-WME-01T-JT Digi International, DC-WME-01T-JT Datasheet - Page 29

• Manufacturer Part Number: DC-WME-01T-JT
• Description: MODULE WI-ME CUSTOMIZABLE JTAG
• Manufacturer: Digi International
• Series: Digi Connect® Wi-MEr

Specifications of DC-WME-01T-JT

• Frequency: 2.4GHz
• Data Rate - Maximum: 11Mbps
• Modulation Or Protocol: 802.11 b
• Applications: General Purpose
• Power - Output: 16dBm
• Sensitivity: -82dBm
• Voltage - Supply: 3.14 V ~ 3.45 V
• Data Interface: PCB, Through Hole
• Memory Size: 4MB Flash, 8MB RAM
• Antenna Connector: RP-SMA
• Operating Temperature: -30°C ~ 75°C
• Package / Case: Module
• Wireless Frequency: 2.4 GHz
• Interface Type: SMA
• Modulation: CCK, DBPSK, DQPSK
• Security: 64/128 WEP, WPA, 802.11i, TKIP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Transmitting: -
• Current - Receiving: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: NS7520
• Other names: 602-1002

GPIO Switch Bank 2, SW2
Reset, SW3
GPIO Switch Bank 2, labeled SW2, is a set of five slide switches that set GPIO inputs to
logic levels of high (switch to left) or low (switch to right).
If the GPIO port is configured as an output, then the switch should always be to the left. If
there is an external device connected to P3, the switch should always be set to the left.
Each GPIO port can be used independently.
Notes
1
2
3
The Reset switch is a push button switch labeled SW3 on the development board. Pressing
the switch holds the Digi Connect ME embedded module in reset. When the push button is
released, the module reboots.
These switches do not determine whether the GPIO is an input or output. That is
determined by the module software.
If GPIO is set to an output by software, switch SW2 must be set to the left (high).
These switches are used with the integration kit and the development kit and in
conjunction with GPIO Switch Bank 1, SW1.
A b o u t t h e D e v e l o p m e n t B o a r d
2 1