DC-WME-01T-JT Digi International, DC-WME-01T-JT Datasheet - Page 13

• Manufacturer Part Number: DC-WME-01T-JT
• Description: MODULE WI-ME CUSTOMIZABLE JTAG
• Manufacturer: Digi International
• Series: Digi Connect® Wi-MEr

Specifications of DC-WME-01T-JT

• Frequency: 2.4GHz
• Data Rate - Maximum: 11Mbps
• Modulation Or Protocol: 802.11 b
• Applications: General Purpose
• Power - Output: 16dBm
• Sensitivity: -82dBm
• Voltage - Supply: 3.14 V ~ 3.45 V
• Data Interface: PCB, Through Hole
• Memory Size: 4MB Flash, 8MB RAM
• Antenna Connector: RP-SMA
• Operating Temperature: -30°C ~ 75°C
• Package / Case: Module
• Wireless Frequency: 2.4 GHz
• Interface Type: SMA
• Modulation: CCK, DBPSK, DQPSK
• Security: 64/128 WEP, WPA, 802.11i, TKIP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Transmitting: -
• Current - Receiving: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: NS7520
• Other names: 602-1002

Connectors: Ethernet Interface
A b o u t t h e D i g i C o n n e c t M E & D i g i C o n n e c t W i - M E E m b e d d e d M o d u l e s
Note
The Ethernet connector is an 8-wire RJ-45 jack that meets the ISO 8877 requirements for
10/100BASE-T. See the following figure and table for pin orientation and pin assignments.
Note
The development board provides a reference design of a POE (Power Over
Pin orientation and assignments are the same for modules with or without a
Ethernet) power supply. A schematic for this reference design is installed by
the setup program on the CD.
JTAG connector.
Power and Device Interface Connector Pin Assignments
17-19
Pin
11
12
13
14
15
16
20
CTS / GPIO 2
DSR / GPIO 3
DCD / GPIO 1
RESET
+3.3V
GND
—
/INIT
Signal
Digi Connect Wi-ME
Clear to Send (Input) / GPIO
Data Set Ready (Input) / GPIO
Data Carrier Detect (Input) / GPIO
Reset
Power
Ground
Reserved. Do not connect.
Software Reset
Description
5