ETRX2 Telegesis Ltd, ETRX2 Datasheet - Page 8

• Manufacturer Part Number: ETRX2
• Description: MODULE ZIGBEE EM250 CHIP ANT
• Manufacturer: Telegesis Ltd

Specifications of ETRX2

• Frequency: 2.4GHz
• Data Rate - Maximum: 250kbps
• Modulation Or Protocol: 802.15.4 Zigbee
• Applications: ISM
• Power - Output: 3dBm
• Sensitivity: -98dBm
• Voltage - Supply: 2.1 V ~ 3.6 V
• Current - Receiving: 35.5mA
• Current - Transmitting: 35.5mA
• Data Interface: PCB, Surface Mount
• Memory Size: 128kB Flash, 5kB SRAM
• Antenna Connector: On-Board, Chip
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Module Applications: AMR, Building Automation, Wireless Sensor Network, M2M Industrial Controls
• Mcu Supported Families: EM250
• Processor Type: EM250
• Wireless Protocol: IEEE 802.15.4
• Data Rate: 250Kbps
• Module Interface: I2C, SPI, UART
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 920-1000-2

EAP-E
For example if you want to change the settings of the serial port speed press ‘1’ followed by
<enter>. Following on you are asked to specify the baudrate (19200), I/F Mode (4C), Flow (00),
port number (10001), and other parameters. To enter a value for a parameter, type the value and
press <enter>, or to confirm a current value, just press enter. When you are finished, save the new
configuration (option 9). The unit reboots.
Please note: When changing the default serial port settings (baudrate, flow control, parity,
TM
data bits), identical settings must be used for the Lantronix® XPort® Direct
and the
ETRX2, otherwise communication will not be possible.
TM
For a detailed description of the menu settings please consult the XPort® Direct
user guide
available from www.lantronix.com.
The DeviceInstaller is used to change the configuration of the EAP-E on the Ethernet side. In most
cases there is no need to alter any of the Ethernet settings and so the DeviceInstaller can usually
be ignored.
©2009 Telegesis (UK) Ltd
- 8 -
EAP-E Product Manual (Rev 1.04)