WISMC03BI Laird Technologies, WISMC03BI Datasheet - Page 12

• Manufacturer Part Number: WISMC03BI
• Description: MODULE LAN 802.11B/G BISM
• Manufacturer: Laird Technologies
• Series: EZURiOr

Specifications of WISMC03BI

• Frequency: 2.4GHz
• Data Rate - Maximum: 1Mbps
• Modulation Or Protocol: 802.11 b/g
• Applications: AMR, Automotive, ISM
• Power - Output: 15dBm
• Sensitivity: -86dBm
• Voltage - Supply: 3.3 V ~ 5.5 V
• Current - Transmitting: 250mA
• Data Interface: Connector, 50 Pin, DF-12
• Memory Size: 64Mbyte Flash, 16MByte SRAM
• Antenna Connector: U.FL
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Wireless Frequency: 2.412 GHz to 2.484 GHz
• Interface Type: UART
• Board Size: 22.8 mm x 33.8 mm x 7.6 mm
• Modulation: BPSK, CCK, DSSS, QPSK
• Security: WEP 64/128, WPA-PSK, WPA2, TKIP, AES-CCMP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Receiving: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

7.
7.1
The module supports the following commands.
Details of the complete command list are provided in a separate Programming Guide, the following are
a provided as an overview.
DSH_WISMC03_0v97 WISM 40 pin SLIP Data Sheet.doc
Command
UARTMODIFY
SECURITY
KEY
AUTHENTICATE
SEARCH
ATTACH
DETACH
BSSTYPE
CHANNEL
MACADDRESS
POWERSAVE
GETRSSI
GETREGION
SETREGION
INITADCCHANNEL
READADCCHANNEL
Firmware Features
Command Set
Parameters
Baud: Baud rate (9600,
19200, 38400, 57600,
115200, 230400, 921600)
Length: 8 bits (only allowed
option)
Parity: Even / Odd
Stop: 1, 2
Flag: none, WEP
Keystring: 10 or 26 Hex digits
setting 64 or 128 bit
encryption key
Flag: Open or closed
Name: Alphanumeric AP SSID
Channel: 1-11 (Europe), 1-13
(US) and 1-14 (Japan)
Flag: Powersave mode
(0,1,2,5)
© 2007-8 EZURiO Ltd
Operation
Configures the UART parameters.
Selects use of WEP security.
(See firmware release notes for other
security parameters)
Sets the WEP encryption key.
(See firmware release notes for other
security parameters)
Selects authentication strategy to use
in combination with WEP.
Performs a search for local Access
Points.
Attaches the module to the specified
Access Point.
Detaches the module from the current
Access Point.
Selects either AP or ad-hoc mode of
operation.
Sets the operating channel for an ad-
hoc network.
Reads back the MAC address of the
module.
Selects the power save mode.
Reports signal strength information for
the current AP connection.
Gets the current region for which the
module is configured.
Sets the region.
Initializes the ADC for a particular
channel.
Reads the specified ADC channel.
Page 12