ATMEGA64RZAPV-10AU Atmel, ATMEGA64RZAPV-10AU Datasheet - Page 8

• Manufacturer Part Number: ATMEGA64RZAPV-10AU
• Description: BUNDLE ATMEGA644P/AT86RF230 TQFP
• Manufacturer: Atmel
• Series: ATMEGAr

Specifications of ATMEGA64RZAPV-10AU

• Frequency: 2.4GHz
• Modulation Or Protocol: 802.15.4 Zigbee
• Power - Output: 3dBm
• Sensitivity: -101dBm
• Voltage - Supply: 1.8 V ~ 3.6 V
• Data Interface: PCB, Surface Mount
• Memory Size: 64kB Flash, 2kB EEPROM, 4kB RAM
• Antenna Connector: PCB, Surface Mount
• Package / Case: 44-TQFP, 44-VQFP
• Wireless Frequency: 2.4 GHz
• Interface Type: SPI, USART
• Output Power: 3 dBm
• For Use With: ATSTK600-TQFP32 - STK600 SOCKET/ADAPTER 32-TQFP770-1007 - ISP 4PORT ATMEL AVR MCU SPI/JTAG770-1005 - ISP 4PORT FOR ATMEL AVR MCU JTAG770-1004 - ISP 4PORT FOR ATMEL AVR MCU SPIATAVRISP2 - PROGRAMMER AVR IN SYSTEMATJTAGICE2 - AVR ON-CHIP D-BUG SYSTEMATSTK500 - PROGRAMMER AVR STARTER KIT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Operating Temperature: -
• Applications: -
• Data Rate - Maximum: -
• Current - Transmitting: -
• Current - Receiving: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATmega64

8
AVR414
Figure 4-1 Jumper Placement on the STK500
Step B. Assemble and attach the STK501 Top Module
The jumpers are now set correctly and the target voltage is set to 3 volts. This
ensures that the AT86RF230 radio transceiver is not damaged and the ATmega1281
will run at 8MHz. The next steps describe how to mount the STK501 top module.
1. Insert an ATmega1281 into the Zero Insertion Force (ZIF) socket on the STK501.
2. Ensure that power is turned off on the STK500 board.
3. Connect the STK501 to the STK500 by using expansion header 0 and 1. Ensure
4. Connect PINE1 and PINE2 to the RXD and TXD pins respectively. This can be
5. To enable the In-System Programmer (ISP) interface, connect a 6-wire cable
Press the spring-loaded top frame of the ZIF down and gently aligning the device
underneath the fine-pitched wires. Verify that pin 1 on the TQFP package (dot in
one of its corners) points towards the notched corner of the ZIF.
that the EXPAND0 written on the STK501 top module aligns with the EXPAND0
written beside the expansion header on the STK500 board.
done using one of the 2-wire cables included in the STK500 starter kit. The RXD
and TXD pins are found close to the 9-pins RS-232 connector on the STK501.
between the ISP6PIN connector on the STK500 board and the SPROG connector
on the STK501 top module as shown in Figure 4-2.
8051A-AVR-11/06