JN5148-EK010 Jennic LTD, JN5148-EK010 Datasheet - Page 20

• Manufacturer Part Number: JN5148-EK010
• Description: KIT EVAL ZIGBEE PRO JN5148
• Manufacturer: Jennic LTD
• Series: JN5148r
• Type: Transceiverr

Specifications of JN5148-EK010

• Frequency: 2.4GHz
• Silicon Manufacturer: Jennic
• Silicon Core Number: JN5148
• Kit Contents: SDK, User Guides, Reference Manual
• Silicon Family Name: Zigbee PRO
• Features: Rapid Application Development And Demonstration
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: ZigBee Pro
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 616-1044; 935294044596; JN5148-EK010

Chapter 3
Home Sensor Demonstration
20
Step 1 Insert the batteries into the boards
Step 2 Attach the antennae to the SMA connectors
Step 3 Power on the Controller board
3.2 Setting Up the Demo System
This section describes how to assemble the demo system, using the Controller board
and three Sensor boards from the evaluation kit, and run the pre-loaded Home Sensor
Demonstration. You must first start the Controller board and then the Sensor boards,
as described in the procedure below.
Insert the supplied AAA batteries into the boards (the required polarities are indicated
on the boards), but do not power on the boards yet.
On each board which has an SMA connector, connect one of the supplied antennae
to the SMA connector - do not over-tighten, finger pressure will be sufficient.
Power on the Controller board using the slide-switch SW6 on the side of the board.
(Sensor board)
(Sensor board)
End Device
Router
Figure 11: Example Demo System Topology
Tip: If you have problems with a board (for example,
failing to join the network), you are advised to reset or
power-cycle the board.
© NXP Laboratories UK 2010
(Controller board)
Parent-Child relationship
Direct radio communication
Co-ordinator
(Sensor board)
End Device
JN-UG-3062 v2.1