101-1165 Rabbit Semiconductor, 101-1165 Datasheet - Page 11

• Manufacturer Part Number: 101-1165
• Description: KIT WIRELESS CONTROL APP 2.4GHZ
• Manufacturer: Rabbit Semiconductor
• Type: RabbitWeb Moduler

Specifications of 101-1165

• Frequency: 2.4GHz
• Wireless Frequency: 7.4 MHz
• Modulation: FHSS
• For Use With/related Products: Rabbit-based Boards
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 316-1132

Set Up Network Connection
1. Go to the control panel (Start > Settings > Control Panel) and double-click the Network Con-
2. Click the “New Connection Wizard,” then press Next to bring up the New Connection Wizard.
3. Select “Set up an advanced connection” and press Next.
4. Select “Connect directly to another computer” and press Next.
5. Select “Guest” and press Next.
6. Enter a specific name for the Rabbit-based device (for example, LP3500) and press Next.
7. Select “Communications cable between two computers…” and press Next.
8. Select “Anyone's use” and press Next, then press Finish.
9. When the dialup window pops up, press the Properties button
10. Verify that the COM port selected previously is displayed under the “General” tab and press the
11. Set the “Maximum speed (bps)” to 9600 and check only the “Enable hardware flow control” box, leave
12. Check “Display progress while connecting” under the “Options” tab in the dialup window, and leave
13. Select “Typical (recommended settings)” and “Allow unsecured password” under the “Security” tab in
14. Press the Settings button under the “Networking” tab, uncheck all the checkboxes, then press OK.
15. Double click “:Internet Protocol (TCP/IP),” then press the Advanced button, uncheck “Use IP header
16. Press OK two more times to close the TCP/IP properties page.
17. Click OK to close the dialup window and save the settings.
The dialup connection should begin and the LP3500 running either sample program will be accessible
wirelessly. The dialup will be repeated a few times before timing out if there is a connection problem. If
you do encounter a connection problem, turn both Interface Boards off, verify that the DB9 connector is
connected securely, then turn the Interface Boards back on.
Double-click the connection you named in Step 6 from the Network Connections window that may be
reached from the control panel (Start > Settings > Control Panel). You may access the LP3500 in the
future from here without having to set up the modem or configure the network parameters again.
What to Expect
If you are running DIRECT_PPP.C on the LP3500, you may ping the LP3500 to demonstrate the PPP
wireless connection. Run the Windows command dialog (Start > Run, then enter cmd) and type the
following ping command:
then click Enter. The window will display the results of the ping. Close the window (exit [return})
when you are done.
nections icon.
Configure button.
the other settings unchecked, and press OK.
other dialing settings unchecked.
the dialup window.
compression” and uncheck “Use default gateway on remote network” under the “General” tab. Now go
to the “WINS” tab and select “Disable NetBIOS over TCP/IP,”.and press OK.
ping 192.168.66.1
022-0115 Rev. A
11