101-1272 Rabbit Semiconductor, 101-1272 Datasheet - Page 69

• Manufacturer Part Number: 101-1272
• Description: KIT MESH NETWORK ADD-ON RCM4510W
• Manufacturer: Rabbit Semiconductor
• Type: Microprocessorr

Specifications of 101-1272

• Product: Modules
• Data Bus Width: 12 bit
• Processor Type: Rabbit 4000
• Sram: 512 KB
• Number Of I/os: 20
• Description/function: Computer Module
• Interface Type: Ethernet
• For Use With/related Products: RCM4510W
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 316-1158

The XBee sample programs in the Dynamic C
the XBee function calls on the XBee RF module on the RCM4510W.
•
User’s Manual
SLEEPMODE.C
the “sleep” mode where most power is removed from the RCM4510W module. Power
is restored once a message is received or after a specified time interval. This sample
program demonstrates waking after a specified time interval.
Sleeping only works on end devices, so the
ENDDEV
sor off and on, a serial terminal emulator is required once the program has been compiled.
Once the XBee RF module on the RCM4510W completes its initialization (it joins the
network), you will be prompted to enter a “sleep” time in milliseconds — enter the
number followed by the
RCM4510W module powers off. When the RCM4510W module powers back up, it
will begin running this program again from the beginning.
1. Compile and run the sample program on the RCM4510W module.
2. Once the sample program is running, choose “Close Connection” from the in Dynamic C
3. Connect the
4. Open the serial port in your serial terminal emulator such as TeraTerm or Hyperterminal to connect to
5. Plug the AC adapter back in to apply power to the Prototyping Board once again.
menu, and unplug the AC adapter supply power to the Prototyping Board.
RCM4510 programming header.
the serial port at 57600 baud.
NOTE: This sample program does not demonstrate the saving state. State information
may be saved in battery-backed RAM before the RCM4510W module is placed in the
sleep mode.
in this sample program. Because the XBee RF module turns the Rabbit proces-
DIAG
—This sample program shows how to place the RCM4510W module in
connector instead of the
Enter
key. There will be a delay of a few seconds before the
PROG
SAMPLES\RCM4500W\XBee
XBEE_ROLE
connector on the programming cable to the
macro is set to
NODE_TYPE_
folder exercise
Run
63