101-1272 Rabbit Semiconductor, 101-1272 Datasheet - Page 19

• Manufacturer Part Number: 101-1272
• Description: KIT MESH NETWORK ADD-ON RCM4510W
• Manufacturer: Rabbit Semiconductor
• Type: Microprocessorr

Specifications of 101-1272

• Product: Modules
• Data Bus Width: 12 bit
• Processor Type: Rabbit 4000
• Sram: 512 KB
• Number Of I/os: 20
• Description/function: Computer Module
• Interface Type: Ethernet
• For Use With/related Products: RCM4510W
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 316-1158

2.2.4 Step 4 — Connect Power
Once all the other connections have been made, you can connect power to the Prototyping
Board.
First, prepare the AC adapter for the country where it will be used by selecting the appro-
priate plug. The RCM4510W Development Kit presently includes Canada/Japan/U.S.,
Australia/N.Z., U.K., and European style plugs. Snap in the top of the plug assembly into
the slot at the top of the AC adapter as shown in Figure 5, then press down on the spring-
loaded clip below the plug assembly to allow the plug assembly to click into place.
Release the clip to secure the plug assembly in the AC adapter.
Connect the AC adapter to 3-pin header J1 on the Prototyping Board as shown in Figure 5.
The connector may be attached either way as long as it is not offset to one side—the center
pin of J1 is always connected to the positive terminal, and either edge pin is ground.
Plug in the AC adapter. The
PWR
LED on the Prototyping Board next to the power con-
nector at J1 should light up. The RCM4510W and the Prototyping Board are now ready to
be used.
NOTE: A RESET button is provided on the Prototyping Board next to the battery holder
to allow a hardware reset without disconnecting power.
To power down the Prototyping Board, unplug the power connector from J1. You should
disconnect power before making any circuit adjustments in the prototyping area, changing
any connections to the board, or removing the RCM4510W from the Prototyping Board.
User’s Manual
13