ATAVRRZ201 Atmel, ATAVRRZ201 Datasheet - Page 23

• Manufacturer Part Number: ATAVRRZ201
• Description: KIT RZ201 CTLR BOARDS & SOFTWARE
• Manufacturer: Atmel
• Series: AVR®r
• Type: 802.15.4/Zigbeer

Specifications of ATAVRRZ201

• Frequency: 2.4GHz
• Wireless Frequency: 2.4 GHz
• Interface Type: JTAG
• Antenna: PCB Trace
• Silicon Manufacturer: Atmel
• Silicon Core Number: ATmega1281V, AT86RF230
• Kit Application Type: Wireless Connectivity
• Application Sub Type: ZigBee Wireless Network
• Silicon Family Name: ZigBee
• Rohs Compliant: Yes
• For Use With/related Products: AT86RF230
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Table 7-1. Troubleshooting
Demonstration Kit User Guide
Problem
No response from any board
The LEDs on the Z-Link RCB
will not illuminate
The Test Button does nothing
The configuration shown in
the Configure screen is not
transmitted to the network
nodes
The Test Button does not
work
The middle LED on the RCB
blinks when I press the Test
Button
RCB lights stay on and the
node will not show up in the
Configure screen
Reason
Power Switch is OFF
Dead Batteries
The RCB is not configured as an
LED Unit
Power Switch is OFF
Dead Batteries
The RCB is not configured as a
Switch Unit
Power Switch is OFF
Dead Batteries
RCB is not attached to the Display
Board
Network nodes are out of range
The RCB batteries are dead
The RCB is out range to the
Coordinator and the Coordinator is
not receiving any packets from the
RCB
The Coordinator has lost power
since going into the Network Monitor
mode
The RCB will not associate if it loses
its MAC address
Possible problems and their solution are shown in Figure 7-1.
Section 7 Troubleshooting
Ensure power switch is ON
Check battery condition and replace if necessary
Check configuration. Only the LEDs on an LED Unit will
illuminate.
Ensure power switch is ON
Check battery condition and replace if necessary
Check configuration. Only the Test Buttons on a Switch Unit
are active and should illuminate an LED on an LED Unit
Ensure power switch is ON
Check battery condition and replace if necessary
Ensure that the RCB is attached to the Display Board
Bring network nodes back into range of the Coordinator
Replace batteries
Go back into the range of the Coordinator
Ensure power switch on Coordinator is ON, or check
Coordinator battery condition and replace if necessary
Reprogram your MAC address (see section 6.2.3)
Solution
5183A–ZIGB–12/07/06
7-1