4320-DKDB2 Silicon Laboratories Inc, 4320-DKDB2 Datasheet - Page 19

• Manufacturer Part Number: 4320-DKDB2
• Description: KIT DEV TEST EZRADIO SI4320 RX
• Manufacturer: Silicon Laboratories Inc

Specifications of 4320-DKDB2

• Accessory Type: Test Card, Receiver, 434MHz
• Wireless Frequency: 434 MHz
• Interface Type: SPI
• Modulation: FSK, OOK
• For Use With/related Products: EZRadio®
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

FIFO Buffered Data Read
In this operating mode, incoming data are clocked into a 16 bit FIFO buffer. The receiver starts to fill up the FIFO when the Valid Data
Indicator (VDI) bit and/or the synchron word recognition circuit indicates potentially real incoming data. This prevents the FIFO from being
filled with noise and overloading the external microcontroller.
For further details see the Receiver Setting Command and the Output and FIFO Command.
Polling Mode:
The nFFS signal selects the buffer directly and its content could be clocked out through pin SDO by SCK. Set the FIFO IT level to 1. In this
case, as long as FFIT indicates received bits in the FIFO, the controller may continue to take the bits away. When FFIT goes low, no more bits
need to be taken. An SPI read command is also available.
Interrupt Controlled Mode:
The user can define the FIFO level (the number of received bits) which will generate the nFFIT when exceeded. The status bits report the
changed FIFO status in this case.
During FIFO access the f
nFFS*
SDO
FFIT
SCK
nSEL
nSDI
FIFO OUT
0
SCK
FO+1
1
FIFO read out
cannot be higher than f
FO+2
2
FO+3
3
NOTE:
*nFFS is used to select FIFO
FO+4
4
ref
/4, where f
ref
is the crystal oscillator frequency.
Si4320
19