MC56F8323VFB60 Freescale Semiconductor, MC56F8323VFB60 Datasheet - Page 95

• Manufacturer Part Number: MC56F8323VFB60
• Description: IC MPU HYBRID DSP 32K 64-LQFP
• Manufacturer: Freescale Semiconductor
• Series: 56F8xxxr

Specifications of MC56F8323VFB60

• Core Processor: 56800
• Core Size: 16-Bit
• Speed: 60MHz
• Connectivity: CAN, SCI, SPI
• Peripherals: POR, PWM, Temp Sensor, WDT
• Number Of I /o: 27
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 12K x 8
• Voltage - Supply (vcc/vdd): 2.25 V ~ 3.6 V
• Data Converters: A/D 8x12b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 105°C
• Package / Case: 64-LQFP
• For Use With: MC56F8323EVME - BOARD EVALUATION MC56F8323
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

6.5.9.11
Each bit controls clocks to the indicated peripheral.
6.5.9.12
Each bit controls clocks to the indicated peripheral.
6.5.9.13
Each bit controls clocks to the indicated peripheral.
6.5.9.14
This bit field is reserved or not implemented. It is read as 1 and cannot be modified by writing.
6.5.9.15
Each bit controls clocks to the indicated peripheral.
6.5.10
The I/O Short Address Location registers are used to specify the memory referenced via the I/O short
address mode. The I/O short address mode allows the instruction to specify the lower six bits of address;
the upper address bits are not directly controllable. This register set allows limited control of the full
address, as shown in
Note:
Freescale Semiconductor
Preliminary
•
•
•
•
•
•
•
•
1 = Clocks are enabled
0 = The clock is not provided to the peripheral (the peripheral is disabled)
1 = Clocks are enabled
0 = The clock is not provided to the peripheral (the peripheral is disabled)
1 = Clocks are enabled
0 = The clock is not provided to the peripheral (the peripheral is disabled)
1 = Clocks are enabled
0 = The clock is not provided to the peripheral (the peripheral is disabled)
I/O Short Address Location Register (SIM_ISALH and SIM_ISALL)
If this register is set ot something other than the top of memory (EOnCE register space) and the EX bit
in the OMR is set to 1, the JTAG port cannot access the on-chip EOnCE registers, and debug functions
will be affected.
Serial Communications Interface 0 Enable (SCI0)—Bit 4
Serial Peripheral Interface 1 Enable (SPI1)—Bit 3
Serial Peripheral Interface 0 Enable (SPI0)—Bit 2
Reserved—Bit 1
Pulse Width Modulator A Enable (PWMA)—Bit 0
Figure
6-13.
56F8323 Technical Data, Rev. 17
Register Descriptions
95