SAK-XC864L-1FRI 5V AA Infineon Technologies, SAK-XC864L-1FRI 5V AA Datasheet - Page 89

• Manufacturer Part Number: SAK-XC864L-1FRI 5V AA
• Description: IC MCU 8BIT 4KB FLASH 20TSSOP
• Manufacturer: Infineon Technologies
• Series: XC8xxr

Specifications of SAK-XC864L-1FRI 5V AA

• Core Processor: XC800
• Core Size: 8-Bit
• Speed: 86MHz
• Connectivity: LIN, SSI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 9
• Program Memory Size: 4KB (4K x 8)
• Program Memory Type: FLASH
• Ram Size: 768 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 20-TSSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

3.19
The On-Chip Debug Support (OCDS) provides the basic functionality required for the
software development and debugging of XC800-based systems.
The OCDS design is based on these principles:
• use the built-in debug functionality of the XC800 Core
• add a minimum of hardware overhead
• provide support for most of the operations by a Monitor Program
• use standard interfaces to communicate with the Host (a Debugger)
Features:
• Set breakpoints on instruction address and within a specified address range
• Set breakpoints on internal RAM address
• Support unlimited software breakpoints in Flash/RAM code region
• Process external breaks
• Step through the program code
The OCDS functional blocks are shown in
block at the center of OCDS system brings together control signals and supports the
overall functionality. The MMC communicates with the XC800 Core, primarily via the
Debug Interface, and also receives reset and clock signals. After processing memory
address and control signals from the core, the MMC provides proper access to the
dedicated extra-memories: a Monitor ROM (holding the code) and a Monitor RAM (for
work-data and Monitor-stack). The OCDS system is accessed through the JTAG
which is an interface dedicated exclusively for testing and debugging activities and is not
normally used in an application.
Note: All the debug functionality described here can normally be used only after XC864
1)
Data Sheet
The pins of the JTAG port can be assigned to either Port 0 (primary) or Ports 1 and 2 (secondary).
User must set the JTAG pins (TCK and TDI) as input during connection with the OCDS system.
has been started in OCDS mode.
On-Chip Debug Support
Figure
85
33. The Monitor Mode Control (MMC)
Functional Description
V 1.1, 2009-03
XC864
1)
,