DEMO9S08DZ60 Freescale Semiconductor, DEMO9S08DZ60 Datasheet - Page 10

• Manufacturer Part Number: DEMO9S08DZ60
• Description: BOARD DEMO
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of DEMO9S08DZ60

• Contents: Board, Cable, CD
• Processor To Be Evaluated: MC9S08DZ60
• Interface Type: RS-232, USB
• Silicon Manufacturer: Freescale
• Core Architecture: HCS08
• Core Sub-architecture: HCS08
• Silicon Core Number: MC9S08
• Silicon Family Name: S08D
• Kit Contents: MC9S08DZ60 Board, Software, Cables, Connectors
• Rohs Compliant: Yes
• For Use With/related Products: MC9S08DZ60
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

D E M O 9 S 0 8 D Z 6 0
Power from the integrated BDM is drawn from the USB bus and is limited to 500 mA. This
current limit accounts for the total current supplied over the USB cable to the BDM circuit, the
target board, and any connected circuitry. Current drain in excess of 500 mA will violate the
USB specification and will cause the USB bus to disconnect. Damage to the host PC or the
target board may also result.
The on-board voltage regulator (VR1) accepts power input through a 2.0mm barrel connector
(PWR). Input voltage may range from +6V to +18V. The voltage regulator (VR1) provides a
+5V fixed output limited to 250mA. Over-temperature and over-current limit built into the
voltage regulator provides protection from excessive stress.
maximum output current limit of VR1 when attempting to power off-board circuitry through
connector J1.
If powered from the PWR connector, the integrated BDM may still be used to develop and
debug application code. Alternately, the board may be powered from the integrated BDM
while the LIN bus is powered from the PWR connector.
VX_EN
The VX_EN option header is a 2-pin jumper that connects or disconnects input J1-1 directly to
the target board +5V voltage rail. J1-3 is directly connected to the ground plane. Use of this
feature requires a regulated +5V input power source.
minimize noise but is not regulated. Care should be exercised when using this feature; no
protection is applied on this input and damage to the target board may result if over-driven.
Also, do not attempt to power the target board through this connector while also applying
power through the USB-Multilink BDM or the PWR connector; damage to the board may result.
Power may also be sourced to off-board circuitry through the J1 connector. The current
supplied from the USB bus or the on-board regulator limits current output to external circuitry.
Excessive current drain may damage the target board, the host PC USB hub, or the on-board
regulator. The figure below details the VX_EN header connections.
Figure 3: VX_EN Option Header
RESET SWITCH
NOTE: Set PWR_SEL jumper to VB during application development. Use barrel connector
CAUTION: Do not exceed available current supply from USB-Multilink BDM or on-board
VX_EN
1
input (PWR) to support LIN functionality if needed.
2
regulator, when sourcing power through connector J1 to external circuitry.
Enabled
ON
Disabled
OFF
10
This power input is decoupled to
The user must consider the
D E C E M B E R
2 ,
2 0 0 6