DK-CYCII-2C20N Altera, DK-CYCII-2C20N Datasheet - Page 41

• Manufacturer Part Number: DK-CYCII-2C20N
• Description: CYCLONE II STARTER KIT EP2C20N
• Manufacturer: Altera
• Series: Cyclone® IIr
• Type: FPGAr

Specifications of DK-CYCII-2C20N

• Contents: Dev Board, Quartus®II Web Edition, Nios®II Web Edition, Cables, Accessories, Reference Designs and Demos
• Silicon Manufacturer: Altera
• Core Architecture: FPGA
• Core Sub-architecture: Cyclone
• Silicon Core Number: EP2C
• Silicon Family Name: Cyclone II
• Rohs Compliant: Yes
• For Use With/related Products: Cyclone®II FPGAs
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 544-1736

Altera Corporation
October 2006
Configuring the EPCS4 Device in AS Mode
Figure 5–2
configuration bit stream into the EPCS4 serial EEPROM device, perform
the following steps:
1.
2.
3.
4.
5.
6.
Refer to the Serial Configuration Devices chapter in the Altera Configuration
Device Handbook for more information about the EPCS4 device.
Ensure that power is applied to the Cyclone II FPGA Starter board
Connect the supplied USB cable to the USB-Blaster port on the
board
Configure the JTAG programming circuit by setting the
RUN/PROG switch (on the left side of the board) to the PROG
position
To program the EPCS4 device, use the Quartus II Programmer
module to select a configuration bit-stream file with the .pof
filename extension
After the programming operation completes, set the RUN/PROG
switch back to the RUN position
Reset the board by turning the power switch off and then on again.
This action causes the new configuration data in the EPCS4 device
to load into the FPGA chip.
illustrates the AS configuration setup. To download a
Cyclone II FPGA Starter Development Kit User Guide
Using the Development Board
5–3