PEB3086 Infineon Technologies, PEB3086 Datasheet - Page 196

• Manufacturer Part Number: PEB3086
• Description: ISDN Subscriber Access Controller
• Manufacturer: Infineon Technologies

CDAx_
CR
DPS ... Data Port Selection
0:The data channel xy of the functional unit XXX is output on DD.
The data channel xy of the functional unit XXX is input from DU.
1:The data channel xy of the functional unit XXX is output on DU.
The data channel xy of the functional unit XXX is input from DD.
Note: For the CDA (controller data access) data the input is determined by the
TSS ... Timeslot Selection
Selects one of 32 timeslots (0...31) on the IOM-2 interface for the data channels.
Note: The TSS reset values for TR_TSDP_BC1/2 are determined by the channel select
4.4.3
Register
CDA1_CR
CDA2_CR
For general information please refer to
EN_TBM ... Enable TIC Bus Monitoring
0: The TIC bus monitoring is disabled
1: The TIC bus monitoring with the CDAx0 register is enabled. The TSDPx0 register
must be set to 08
(This selection is only valid if IOM_CR.TIC_DIS = 0).
Data Sheet
CDA_CRx.SWAP bit. If SWAP = ’0’ the input for the CDAxy data is vice versa to
the output setting for CDAxy. If the SWAP = ’1’ the input from CDAx0 is vice versa
to the output setting of CDAx1 and the input from CDAx1 is vice versa to the output
setting of CDAx0. See controller data access description in
pins CH2-0 which are mapped to the corresponding bits TSS4-2.
7
CDAx_CR - Control Register Controller Data Access CH1x
0
H
for monitoring from DU or 88
0
TBM
EN_
Register Address
4E
4F
H
H
EN_I1 EN_I0 EN_O1 EN_O0 SWAP
Chapter
196
3.7.1.1.
H
for monitoring from DD, respectively
Detailed Register Description
Value after Reset
00
00
H
H
0
Chapter
3.7.1.1.
PEB 3086
2003-01-30
ISAC-SX
RD/WR
(4E-4F)