hdmp-1526 ETC-unknow, hdmp-1526 Datasheet - Page 12
![no-image](/images/no-image-200.jpg)
hdmp-1526
Manufacturer Part Number
hdmp-1526
Description
Fibre Channel Transceiver Chip
Manufacturer
ETC-unknow
Datasheet
1.HDMP-1526.pdf
(14 pages)
TRx I/O Definition (cont’d.)
GND_RXTTL
VCC_TXECL
VCC_RXTTL
GND_RXHS
GND_TXHS
VCC_RXHS
VCC_TXHS
GND_RXA
BYTSYNC
VCC_RXA
RXCAP0
RXCAP1
+DOUT
-DOUT
Name
RX[0]
RX[1]
RX[2]
RX[3]
RX[4]
RX[5]
RX[6]
RX[7]
RX[8]
RX[9]
RBC1
RBC0
+DIN
-DIN
Pin
29
37
42
30
31
32
33
46
45
44
43
41
40
39
38
36
35
34
47
48
49
50
51
52
54
53
55
56
60
63
61
62
64
HS_OUT Serial Data Outputs: High-speed outputs. These lines are active when
O-TTL
O-TTL
O-TTL
HS_IN
Type
C
S
S
S
S
S
S
S
S
S
TTL Power Supply: Normally 5 volts. Used for all TTL receiver output
buffer cells.
Receiver Byte Clocks: The receiver section recovers two 53.125 MHz
receive byte clocks. These two clocks are approximately 180 degrees out
of phase. The receiver parallel data outputs are alternatively clocked on
the rising edge of these clocks. RBC1 aligns and outputs the comma
character (for byte alignment) when detected.
TTL Receiver Ground: Normally 0 volts. Used for the TTL output cells
of the receiver section.
Data Outputs: One 10 bit data byte. RX[0] is the first bit received.
RX[0] is the least significant bit.
Byte Sync Output: An active high output. Used to indicate detection of
either a comma character or a K28.5 special character of positive
disparity. It is only active when ENBYTSYNC is enabled.
Loop Filter Capacitor: A loop filter capacitor for the internal PLL is
connected across the RXCAP0 and RXCAP1 pins.
(typical value = 0.01 F).
Analog Power Supply: Normally 5 volts. Used to provide a clean supply
line for the PLL and high-speed analog cells.
Analog Ground: Normally 0 volts. Used to provide a clean ground
plane for the receiver PLL and high-speed analog cells.
Serial Data Inputs: High-speed inputs. Serial data is accepted from the
High-Speed Supply: Normally 5 volts. Used only for the high-speed
receiver cell (HS_IN). Noise on this line should be minimized for best
operation.
Ground: Normally 0 volts.
High-Speed ECL Supply: Normally 5 volts. Used only for the last stage
of the high-speed transmitter output cell (HS_OUT) as shown in
Figure 9. Due to high current transitions, this V
bypassed to a ground plane.
High-Speed Supply: Normally 5 volts. Used by the transmitter side
for the high-speed circuitry. Noise on this line should be minimized
for best operation.
LOOPEN is set low. When LOOPEN is set high, these outputs are held
static.
Ground: Normally 0 volts.
DIN inputs when LOOPEN is low.
Signal
CC
should be well
693