GS1559 Gennum Corp., GS1559 Datasheet - Page 61

• Manufacturer Part Number: GS1559
• Description: GS1559 HD-LINX-TM II Multi-Rate Deserializer with Loop-Through Cable Driver
• Manufacturer: Gennum Corp.

4.11 Parallel Data Outputs
4.11.1 Parallel Data Bus Buffers
Data outputs leave the device on the rising edge of PCLK as shown in
and
The data may be scrambled or unscrambled, framed or unframed, and may be
presented in 10-bit or 20-bit format. The output data bus width is controlled
independently from the internal data bus width by the 20bit/10bit input pin.
Likewise, the output data format is defined by the setting of the external SD/HD,
SMPTE_BYPASS and DVB_ASI pins. Recall that in slave mode, these pins are set
by the application layer as inputs to the device. In master mode, however, the
GS1559 sets these pins as output status signals.
The parallel data outputs of the GS1559 are driven by high-impedance buffers
which support both LVTTL and LVCMOS levels. These buffers use a separate
power supply of +3.3V DC supplied via the IO_VDD and IO_GND pins.
All output buffers, including the PCLK output, may be driven to a high-impedance
state if the RESET_TRST signal is asserted LOW.
Note that the timing characteristics of the parallel data output buffers are optimized
for 10-bit HD operation. As shown in
is 1.5ns.
Due to this optimization, however, the output data hold time for SD data is so small
that the rising edge of the PCLK is nearly incident with the data transition. To
improve output hold time at SD rates, the PCLK output is inverted is SD mode,
(SD/HD = HIGH). This is shown in
Control signal
Figure 4-7: HD PCLK to Data Timing
30572 - 4
DOUT[19:0]
Figure
output
PCLK
4-8.
July 2005
HD MODE
DATA
Figure
Figure
t
OH
t
OD
4-8.
4-7, the output data hold time for HD
GS1559 Data Sheet
Figure 4-7
61 of 74