USB3280-AEZG-TR Standard Microsystems (SMSC), USB3280-AEZG-TR Datasheet - Page 26

• Manufacturer Part Number: USB3280-AEZG-TR
• Manufacturer: Standard Microsystems (SMSC)

Revision 1.5 (11-15-07)
7.6
7.6.1
7.6.2
SIGNALING MODE
Tri-State Drivers
Power-up
Peripheral Chirp
Peripheral HS
Peripheral FS
Peripheral HS/FS Suspend
Peripheral HS/FS Resume
Peripheral Test J/Test K
USB 2.0 Transceiver
The SMSC Hi-Speed USB 2.0 Transceiver consists of the High Speed and Full Speed Transceivers,
and the Termination resistors.
High Speed and Full Speed Transceivers
The USB3280 transceiver meets all requirements in the USB 2.0 specification.
The receivers connect directly to the USB cable. This block contains a separate differential receiver
for HS and FS mode. Depending on the mode, the selected receiver provides the serial data stream
through the multiplexer to the RX Logic block. The FS mode section of the FS/HS RX block also
consists of a single-ended receiver on each of the data lines to determine the correct FS linestate. For
HS mode support, the FS/HS RX block contains a squelch circuit to insure that noise is never
interpreted as data.
The transmitters connect directly to the USB cable. The block contains a separate differential FS and
HS transmitter which receive encoded, bit stuffed, serialized data from the TX Logic block and transmit
it on the USB cable.
Termination Resistors
The USB3280 transceiver fully integrates all of the USB termination resistors. The USB3280 includes
the 1.5kΩ pull-up resistor on DP. In addition the 45Ω high speed termination resistors are also
integrated. These integrated resistors require no tuning or trimming. The state of the resistors is
determined by the operating mode of the PHY. The possible valid resistor combinations are shown in
Table
RPU_DP_EN activates the 1.5kΩ DP pull-up resistor
HSTERM_EN activates the 45Ω DP and DM high speed termination resistors
7.1.
Table 7.1 DP/DM Termination vs. Signaling Mode
DATASHEET
26
UTMI+ INTERFACE SETTINGS
Xb
1b
0b
0b
1b
1b
1b
0b
Hi-Speed USB Device PHY with UTMI Interface
Xb
0b
1b
0b
1b
1b
1b
0b
01b
00b
10b
00b
00b
00b
10b
10b
0b
0b
1b
0b
1b
1b
1b
0b
RESISTOR
SETTINGS
SMSC USB3280
Datasheet
0b
0b
0b
1b
0b
0b
0b
1b