Z4LBA1040V2 Omron, Z4LBA1040V2 Datasheet - Page 6

• Manufacturer Part Number: Z4LBA1040V2
• Manufacturer: Omron

Specifications of Z4LBA1040V2

• Lead Free Status / Rohs Status: Supplier Unconfirmed

Table
6
Function
Display
Functions
Adjustments Threshold setting function
Logic
j
continued from previous page
LD (laser diode) ON indicator
Display (with measurement unit
selection and light/dark mode
selection functions)
HIGH/PASS indicator
LOW/NG indicator
Forced-zero indicator
Hold (refer to the following page)
Backup
Response time selection
Gain adjustment
(for standard model only)
OFF delay
Direct setting
Teaching setting
g
The thresholds are set to desired values by teaching.
The HIGH threshold output turns ON when the HIGH threshold is equal to
or below a measured value. The LOW threshold output turns ON when the
LOW threshold is equal to or above a measured value.
The thresholds are set to desired values by using the Right Key, Up
Key, and SET Key.
Description
Lights when laser beams are emitted.
The Sensor and Amplifier indicators light at the same time.
Displays either linear output voltage (V) or length (mm) according to the
measurement unit selector switch setting.
If the measurement unit is set to length (mm), set the measurement
width to be used. The default setting is 10 mm.
The amount of incident light or light interruption can be selected using
the light/dark mode selector switch.
Lights when HIGH/PASS discrimination output turns ON.
Lights when LOW/NG discrimination output turns ON.
Lights when the forced-zero settings are enabled in RUN mode.
(displayed as the lowest decimal place)
Holds the display and output values.
One of the following six hold methods can be selected according to the
application: Peak hold, bottom hold, sample hold, peak-to-peak hold,
self-peak hold, self-bottom hold.
The default setting is normal.
Specifies whether to back up the forced-zero set value. If the value is
to be retained after the Sensor is turned OFF, always enable the
backup.
The default setting is enabled.
The resolution changes with the response time. Select the required
response time, taking the resolution into consideration.
Adjusts the full scale of linear output and display.
The HIGH/LOW discrimination outputs will have a 40-ms OFF delay
if the OFF delay selector is set to ON.
Switch
FAST
SLOW
Response time
0.3 ms
5 ms