Z4LBA1040V2 Omron, Z4LBA1040V2 Datasheet - Page 16

• Manufacturer Part Number: Z4LBA1040V2
• Manufacturer: Omron

Specifications of Z4LBA1040V2

• Lead Free Status / Rohs Status: Supplier Unconfirmed

Precautions
J DESIGNING THE SETUP
Compatibility
There is general compatibility between Sensors and Amplifiers
for standard models. The emitters and the receivers are
inspected as sets before delivery. Operation is possible using the
emitters or the receivers from other sets, but in order to satisfy
specifications, the serial number of the emitter and the receiver
must be the same.
With high-precision models, the Sensor and the Amplifier are
adjusted as a set. Use only combinations with the same serial
number.
Mutual Interference
Operation is possible with two or more Sensors mounted
together, but operation is not possible with two or more beams in
close proximity. If the Sensor is used in this way, it may cause
malfunction.
J WIRING PRECAUTIONS
Wiring and Power Supply
Do not impose voltage exceeding the rated voltage, or the
Sensor may be damaged.
When supplying power to the Sensor, make sure that the polarity
of the power is correct, or the Sensor may be damaged.
Do not short-circuit the load supplied with open collector output,
or the Sensor may be damaged.
Do not lay a power supply cable for the Z4LB V2 together with
high-voltage lines or power lines to prevent interference,
damage, and malfunction.
The Z49-C13 Extension cable (3 or 8 m in length) can be
connected to the Sensor cable or Amplifier cable. The total length
of the Sensor cable or Amplifier cable, however, must be 10 m or
less. To extend the Amplifier cable, a shielded cable that is the
same as that of the Amplifier cable must be used.
Use an isolation transformer for the power supply of the Z4LB V2
as shown below. Do not use an autotransformer (single-winding
transformer).
16
Commercial
power supply
Commercial
power supply
Incorrect
Correct
Isolation transformer
Autotransformer
+
+
- -
- -
Z4LB V2
Z4LB V2
J MAINTENANCE
Install the Sensor in a clean environment and keep the filter on
the front panel of the Sensor free from oil and dust. If affected by
oil or dust, clean the filter as follows:
1. Use a blower brush (used to clean camera lenses) to blow
2. Use a soft cloth (for lenses) with a small amount of alcohol to
Note: Do not use a scrubbing action when cleaning because
J ENVIRONMENT
Do not use the Sensor in strong electromagnetic fields or in an
environment where the operation of the Sensor is subject to the
reflection of intense light (such as other laser beams or electric
arc-welding machines.)
The Sensor may not be able to accurately detect objects of
certain materials or shapes.
J MOUNTING THE SIDE-VIEW
Handling Precautions
Do not apply excessive shock to the Attachment. Doing so may
result in damage.
Mounting Precautions
D
D
large dust particles from the surface. Do not blow the dust
away with your mouth.
remove the remaining dust.
ATTACHMENT
Do not touch any internal parts when mounting. Dirt inside
the Attachment may affect the high-performance reflective
mirror inside and cause malfunction.
When mounting the Attachment, tighten the mounting
screws to a torque not exceeding 0.2 N S m.
scratches on the filter could result in the Sensor malfunc-
tioning.