AS3930-BQFT austriamicrosystems, AS3930-BQFT Datasheet - Page 18

• Manufacturer Part Number: AS3930-BQFT
• Description: IC RF PROGRAM RECEIVER 16-QFN
• Manufacturer: austriamicrosystems

Specifications of AS3930-BQFT

• Rf Type: Read / Write
• Frequency: 110kHz ~ 150kHz
• Features: RSSI Equipped
• Package / Case: 16-VFQFN Exposed Pad
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: AS3930-BQFTTR

AS3930
Data Sheet - D e t a i l e d D e s c r i p t i o n
Figure 15. Send Direct COMMAND Byte
8.4 Channel Amplifier and Frequency Detector
The channel amplifier consists of a variable gain amplifier (VGA), an automatic gain control, and a frequency detector. The latter detects the
presence of a carrier. As soon as the carrier is detected the AGC is enabled, the gain of the VGA is reduced and set to the right value and the
RSSI can be displayed.
8.4.1 Frequency Detector / AGC
The frequency detection uses the RTC as time base. In case the internal RC oscillator is used as RTC, it must be calibrated, but the calibration
is guaranteed for a 32.768 kHz crystal oscillator only. The frequency detection criteria can be tighter or more relaxed according to the setup
described in
Table 13. Tolerance settings for Wakeup
The AGC can operate in two modes:
As soon as the AGC starts to operate, the gain in the VGA is set to maximum. If the AGC down only mode is selected, the AGC can only
decrease the gain. Since the RSSI is directly derived from the VGA gain, the system holds the RSSI peak.
When the AGC up and down mode is selected, the RSSI can follow the input signal strength variation in both directions.
Regardless which AGC operation mode is used, the AGC needs maximum 35 carrier periods to settle.
The RSSI is stored in the register R10<4:0>.
Both AGC modes (only down or down and up) can also operate with time limitation. This option allows AGC operation only in time slot of 256µs
following the internal wake-up. Then the AGC (RSSI) is frozen till the wake-up or RSSI reset occurs.
The RSSI is reset either with the direct command 'clear_wakeup' or 'reset_RSSI'. The 'reset_RSSI' command resets only the AGC setting but
does not terminate wake-up condition. This means that if the signal is still present the new AGC setting (RSSI) will appear not later than 300µs
(35 LF carrier periods) after the command was received. The AGC setting is reset if for duration of 3 Manchester half symbols no carrier is
detected. If the wake-up IRQ is cleared the chip will go back to listening mode.
www.austriamicrosystems.com/AS3930
AGC down only (R1<5>=0)
AGC up and down (R1<5>=1)
R2<1:0>(see Table
R2<1>
0
0
1
1
13).
R2<0>
0
1
0
1
Revision 1.0
tighter (medium)
Tolerance
Reserved
stringent
relaxed
18 - 33