DVK-WLM400 Laird Technologies, DVK-WLM400 Datasheet - Page 22

• Manufacturer Part Number: DVK-WLM400
• Description: DEVELOPMENT KIT WISM+
• Manufacturer: Laird Technologies
• Type: Transceiverr

Specifications of DVK-WLM400

• Frequency: 2.4GHz
• Processor Series: WISM+
• Silicon Manufacturer: Laird Technologies
• Kit Application Type: Communication & Networking
• Application Sub Type: Wi-Fi Intelligent Serial
• Kit Contents: PCB, 2x Antennas, Power Adapter, USB Cable, RS-232
• Rohs Compliant: Yes
• For Use With/related Products: WLM400
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

4.2.3 Starting WIF.exe over PC Ethernet port
If everything is working properly, you will see the WIF front screen populated with the current state saved in WISM+
constant memory.
Now go to section: “
•
•
•
•
•
© Laird Technology 2010
Since WIF.exe is looking for the USB connection upon launch, MAKE SURE THE USB CABLE IS
DISCONNECTED
Connect a network cable between the WISM+ Dev Kit Ethernet port and the PC’s Ethernet port.
Make sure you have followed the steps in section: “
Power up the WISM+ Dev Kit (or press the reset button) and wait for the “Run Led” to begin flashing at a 1Hz
rate.
Now launch Wif.exe by clicking…
You will then see WIF.exe’s interface selection screen as shown below…
Select Ethernet
Select the Ethernet adapter
associated your PC’s wired
network connection,
WIF.exe Operation
Click OK.
.
StartAll ProgramsWism+Wism+ Config Tool
”.
Configuring PC Ethernet port for WIF.exe
Version 1.00
WISM+ DVK MANUAL
.
Page 17
”.