HD64F3048BF25 Renesas Electronics America, HD64F3048BF25 Datasheet - Page 673

• Manufacturer Part Number: HD64F3048BF25
• Description: IC H8 MCU FLASH 128K 100QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of HD64F3048BF25

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 8MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 70
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

20.3
20.3.1
When the SSBY bit is cleared to 0 in SYSCR, execution of the SLEEP instruction causes a
transition from the program execution state to sleep mode. Immediately after executing the SLEEP
instruction the CPU halts, but the contents of its internal registers are retained. The DMA
controller (DMAC), refresh controller, and on-chip supporting modules do not halt in sleep mode.
Modules which have been placed in standby by the module standby function, however, remain
halted.
20.3.2
Sleep mode is exited by an interrupt, or by input at the RES or STBY pin.
Exit by Interrupt: An interrupt terminates sleep mode and causes a transition to the interrupt
exception handling state. Sleep mode is not exited by an interrupt source in an on-chip supporting
module if the interrupt is disabled in the on-chip supporting module. Sleep mode is not exited by
an interrupt other than NMI if the interrupt is masked by the I and UI bits in CCR and IPR.
Exit by RES
Exit by STBY
mode.
20.4
20.4.1
To enter software standby mode, execute the SLEEP instruction while the SSBY bit is set to 1 in
SYSCR.
In software standby mode, current dissipation is reduced to an extremely low level because the
CPU, clock, and on-chip supporting modules all halt. The DMAC and on-chip supporting modules
are reset. As long as the specified voltage is supplied, however, CPU register contents and on-chip
RAM data are retained. The settings of the I/O ports and refresh controller * are also held.
Note: * RTCNT and bits 7 and 6 of RTMCSR are initialized. Other bits and registers hold their
RES Input: Low input at the RES pin exits from sleep mode to the reset state.
RES
RES
STBY
STBY
STBY Input: Low input at the STBY pin exits from sleep mode to hardware standby
Transition to Sleep Mode
Exit from Sleep Mode
Transition to Software Standby Mode
Sleep Mode
Software Standby Mode
previous states.
Rev. 3.00 Sep 27, 2006 page 645 of 872
Section 20 Power-Down State
REJ09B0325-0300