PDH10-37 Panduit Corp, PDH10-37 Datasheet - Page 37

• Manufacturer Part Number: PDH10-37
• Description: HOSE AIR SUPPLY
• Manufacturer: Panduit Corp
• Type: Accessory, Hoser

Specifications of PDH10-37

• Features: -
• For Use With/related Products: -

"TIE IN TOOL” ADDENDUM
Turning new "Tie in Tool" feature "ON" or "OFF"
Level 1 - Operator Menu ("Load, Unload, Menu" Display)
Loads:
Load
Level 1B - Loading commands disappear
Level 2 - SETUP MENU ACCESS
Resets load and/or counter
Reset Ld
Level 3 - Total Counts Menu
Shows total counts
Counters
LEVEL 3A - Dispenser and Tool Counts
PDM
PAT1M
If "Tie in Tool" feature is turned "ON" and you want to turn it "OFF", just repeat this process.
ERROR 6 - Tie in Tool
Tie in Tool
POSSIBLE CAUSE: This occurs if the cable tie reaches the tool, but is prevented from completing the cycle.
This may be due to a large air pressure drop, too large of a bundle; improper feeder hose connections, an
obstruction blocking the cable tie path; a severe bend or twist in the feeder hose, or the tool jaws are opened
during the cycle.
CORRECTIVE ACTION: Remove the cable tie and any obstruction from the jaw area. Resume operation.
PREVENTION: To prevent this problem from recurring, verify that the feeder hose connections are secure and
that there are no severe bends or twists in the feeder hose. Verify that the maximum bundle diameter does not
exceed .82" (21mm) for the PAT1M Tool; and 1.31" (33mm) for the PAT1.5M Tool. Also, verify that the air
pressure is between 65 and 85 PSIG (4,5 and 5,8 bar), with a maximum 10 PSI (0,7 bar) drop.
PAT1M/PAT1.5M: PA22222A01_03
14
# XXXXXX
# XXXXXX
Unload
Escape
Reset Ct
Rev X.X
PAT1M / PAT1.5M OPERATION MANUAL
MENU
MENU
MENU
MENU
Cycles:
Cycles:
XXXXXXX
XXXXXXX
XXXXXXX
Exit
XXXXXXX
Exit
Buzzer
Page: 35 of 36
XXXXXXX
XXXXXXX
1. Press BUTTON 3, two times
2. Press BUTTON 2, two times
3. Press BUTTON 3, one time
4. Then press BUTTON 4 to exit
5. Then press ESCAPE button
1. Press BUTTON 3, two times
2. Press BUTTON 1, one time
3. Brings up Level 3
(Note: Count buttons from left to right)
Press the COUNTERS button
PDM Software, Revision 0.8 or higher
From either of these screens,
Press the MENU button
from Level 3 menu (above)
Dec., 2007