220015-6 Tyco Electronics, 220015-6 Datasheet - Page 2

• Manufacturer Part Number: 220015-6
• Description: TOOL HAND CRIMP HEAVY HEAD
• Manufacturer: Tyco Electronics

Specifications of 220015-6

• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Features: -
• For Use With/related Products: -
• Tool Type: -

3.2. Crimping the Ferrule
Assemble the connector body over the crimped
contact as described in connector instructions and
proceed as follows:
NOTE:
2 of 6
Crimping Center Contact
TOOL NO.
1. Determine contact type (long or short) from the
dimensions provided in Figure 2. Rotate
locator/stop by turning adjustment cap to OPEN
position for long- -type contacts, or CLOSED
position for short- -type contacts.
2. Insert conductor into contact wire barrel until
contact butts against cable dielectric, and place
contact in tool head as shown in Figure 2.
3. Push cable IN to hold center contact against
and perpendicular to locator/stop. MAKE SURE
that the raised area on the contact wire barrel is
located ON the crimping die for proper termination.
4. Close tool handles FULLY until ratchet releases
to complete crimp. Note that once the ratchet is
engaged, handles cannot be opened until they
have been fully closed.
220015
(Male or Female)
Typical
Short
Contact
--1
--2
--3
--4
--6
Typical
Long
Contact
For long contacts, rotate locator- - stop to
the open position; short contacts require
the closed position.
LONG (min)
22.02 [.867]
21.36 [.841]
22.02 [.867]
26.04 [1.025]
22.02 [.867]
CONTACT TYPE
Rotate Locator- -
Stop as Required
SHORT (max)
End of Contact
Must be Located
in Locator- - Stop
Recess
17.45 [.687]
16.81 [.662]
17.45 [.687]
21.51 [.847]
17.45 [.687]
Tyco Electronics Corporation
CABLE
SIDE
Figure 2
Crimping Ferrule
Typical R.F.
Connector
Braid Crimp
Locate Connector
in Tool Exactly
as Shown
1. Place connector assembly in tool as shown in
Figure 3. MAKE SURE that the ferrule assembled
on the cable is on the upper crimping die, and that
the shoulder on the connector rests against the
die, as shown.
2. Close handles until CERTI--CRIMP hand
crimping tool ratchet control releases to complete
crimp.
CABLE
SIDE
Figure 3
Raised Area on Contact Wire Barrel
Must be Located on Crimping Die
Place Connector and
Ferrule, Assembled on
Cable, in Upper
Crimping Die
Shoulder on
Connector
Rests Against
Die
Push Cable
IN to Hold
Center Contact
Against and
Perpendicular
to Locator- - Stop
Dielectric Butts
Against Center
Contact
Rev B