63811-7900 Molex Inc, 63811-7900 Datasheet - Page 4

• Manufacturer Part Number: 63811-7900
• Description: TOOL HAND CRIMP 28-32AWG 1.25MM
• Manufacturer: Molex Inc
• Series: PremiumGrade™, PanelMate™, Pico-Gold™r
• Type: Crimp Toolr

Specifications of 63811-7900

• Tool Type: Hand Crimper
• Features: Side Entry, Ratchet
• Product: Crimping, Stripping & Cutting Tools & Drills
• Crimp Size: 32AWG To 28AWG
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• For Use With/related Products: Rectangular Contacts, 28-32 AWG
• For Use With: WM5506TR - CONN TERM FEMALE 28-30AWG GOLD50753-8141 - CONN TERMINAL 30-32AWG CRIMP0505168041 - CONN TERM FEMALE 28-32AWG GOLDWM5506 - CONN TERM FEMALE 28-30AWG GOLD
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 063811-7900; 063811-7900-E; 0638117900; 0638117900-E; 63811-7900-E; 638117900; 638117900-E; WM9805

Hand Crimp Tool for 1.25mm (.049”) Pitch Crimp Terminals
Doc No: ATS-638117900
Revision: B
Locator Replacement
See the parts list on the last page of this document
for the proper locator order number. Follow the
steps below to replace the locator.
1. Open the crimp hand tool.
2. Squeeze gently on the lower area shown in
3. Lift and pull away from the hand tool. The top
4. To reinstall the new locator, make sure the hand
5. Press the red insert down as far as it will go as
6. Holding onto the lower part of the locator with
7. Rotate the locator down and press the lower tabs
Figure 7A with your thumb and index finger.
The lower tabs of the locator should disengage
from the hand tool.
locator hooks should slip out of the top slots
easily. See Figure 7A.
tool is in the open position.
shown in Figure 7B.
your thumb and index finger, insert the locators
top hooks (2) into the hand tool top slots.
into the two bottom slots of the hand tool. To
secure the locator into place, the lower tabs must
snap into place on the hand tool frame.
TERMINAL
WIRE STOP
Figure 6
WIRE
Release Date: 05-31-07
Revision Date: 04-28-08
SQUEEZE
UNCONTROLLED COPY
M3 BHCS
HERE
Note:
A crimp height chart is provided with this manual as
Reference Only. Due to the wide range of wires,
strands, insulation diameters, and durometers
available, actual crimp height measurements may very
slightly. An occasional, destructive, pull force test
should be performed to check hand tool crimp. Pull
Force value Must exceed the Minimum pull force
specifications listed.
TOOLING
Figure 7A
LOWER TABS
Figure 8
PULL OPEN
LOCATOR
JAWS OPEN
TOP SLOTS OF
PUSH ON
TOP HOOKS
HANDLE
HANDTOOL
SQUEEZE
HERE
CENTER OF LOCATOR
DOWN POSITION
MAKE SURE
IS IN THE
Figure 7B
Page 4 of 8
TOOLING