58433-1 Tyco Electronics, 58433-1 Datasheet - Page 3

• Manufacturer Part Number: 58433-1
• Description: PRO CR ASSY W/RG58/59 O IS9140
• Manufacturer: Tyco Electronics
• Series: Pro-Crimper™ IIIr
• Type: Crimpersr

Specifications of 58433-1

• Tool Type: Hand Crimper
• Features: Side Entry, Ratchet
• Rohs Compliant: NA
• Product: Crimping, Stripping & Cutting Tools & Drills
• Description/function: BNC Dual O Crimp Commercial
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• For Use With/related Products: Coaxial, RF - BNC, TNC
• For Use With: 8-34163-1 - CONN RING 14-16 AWG #5/16 P-G
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 58433-1; A24786

4.3. Ratchet Adjustment
The ratchet mechanism features an adjustment wheel
with eight settings. The adjustment wheel controls the
amount of handle pressure exerted on the tool jaws
and crimping dies during crimping. If the crimp is not
acceptable, adjust the ratchet as follows:
If the crimp cannot be made to conform to the
dimensions provided in the appropriate product
application specification, the tool and/or dies are
defective and must be replaced.
Rev C
PRO-CRIMPER III Hand Crimping Tool 583433-1
1. Sufficiently loosen the screw at the ratchet
adjustment wheel so that the wheel can be rotated
above the post that engages the teeth in the wheel.
2. If the crimp is too loose, turn the wheel to a
higher notch (for example, if the wheel is set at
notch no. 5, move the wheel to notch no. 6). If the
crimp is too tight, move the wheel to a lower notch.
3. Tighten the screw at the ratchet adjustment
wheel.
1.27 mm
.050 in.
1.09 mm
.043 in.
+.003
–.002
+.003
–.001
+.08
–.05
+.08
–.03
Tyco Electronics Corporation
Figure 5
5. PARTS REPLACEMENT
Customer–replaceable parts are shown in Figure 1.
Available separately, PRO–CRIMPER III Repair Kit
679221–1 includes a variety of pins, rings, screws,
and springs. If the dies are damaged or worn
excessively, they must be replaced. Order the repair
kit and replaceable parts through your Tyco
Electronics representative, or call 1–800–526–5142,
or send a facsimile of your purchase order to
1–717–986–7605, or write to:
6. REVISION SUMMARY
Since the previous release of this document, The TE
logo was applied.
NOTE
Customer Service (38–35)
Tyco Electronics
P.O. Box 3608
Harrisburg, PA 17105–3608
i
Other dies of the PRO-CRIMPER III Series Hand
Criming Tool may be used in this tool; however,
the ratchet adjustment wheel may require
adjustment to achieve acceptable crimp height.
[.240 in. + .004]
6.10 mm + .10
[.208 in. + .004]
5.28 mm + .10
408-9140
3 of 3