I310S Fluke Electronics, I310S Datasheet - Page 7
I310S
Manufacturer Part Number
I310S
Description
CURRENT PROBE AC/DC
Manufacturer
Fluke Electronics
Type
AC/DC Clamp, Hall Effectr
Datasheet
1.I310S.pdf
(8 pages)
Specifications of I310S
Style
Pincer
Ac Current Range
30 ~ 300A rms
Bandwidth
20kHz
Cable Length
78.740" (2000.00mm)
Dc Current Range
45A ~ 450A
Max Conductor Size
0.748" (19.00mm)
Termination
BNC
Ratings
CAT III 300V
Lead Free Status / RoHS Status
Lead free by exemption / RoHS compliant by exemption
Other names
2840309
Current Measurement
Maintenance
Cleaning
Clean the case periodically by wiping it with a damp cloth and
detergent. Do not use abrasive cleaners or solvents. Do not
immerse the Clamp in liquids.
Battery Replacement
The red LED will flash when the minimum operating voltage is
approached. Refer to Figure 1. Use the following procedure:
1.
2.
3.
4.
5.
To avoid personal injury, always ensure the Clamp
is removed from any live electric circuit, and leads
are disconnected before removing the battery cover.
Never operate the Clamp without the battery cover
fitted.
1.
2.
Replacement with other than the specified type of
battery will invalidate the warranty.
Fit only the type 9 V PP3 Alkaline (MN 1604).
Switch on the Clamp to the required current range and
check that the LED is lit.
Connect the output lead to an oscilloscope, multimeter,
or other measuring equipment.
If necessary, adjust the Clamp output voltage to zero as
described in section Zero Adjustment.
Clamp the jaw around the conductor ensuring a good
contact between the closing faces of the jaws.
Observe and take measurements as required. Positive
output indicates that the current flow is in the direction
shown by the arrow on the Clamp.
Unclamp from the conductor, turn it off using the On –
Off switch and disconnect the output leads, from
external equipment.
Loosen the captive screw that secures the battery
cover. Lift the cover through 30° and pull it clear of the
Clamp body as shown in Figure 1. The battery is then
accessible. Replace the battery and re-fit the battery
cover and fasten the screw.
WX
Note
Warning