HS2556EPI61H Renesas Electronics America, HS2556EPI61H Datasheet - Page 206

• Manufacturer Part Number: HS2556EPI61H
• Description: EMULATOR BASE H8SX/2556
• Manufacturer: Renesas Electronics America

Specifications of HS2556EPI61H

• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

[General] page (cont)
The MCUs selectable by the [Device] option and options that depend on the MCUs are listed below. To emulate
an MCU with a description in the Expansion Hardware column, connect the correct expansion hardware.
Table 8.2
[Device]
Option
Custom
H8S/2556
H8S/2552
H8S/2551
H8S/2506
H8S/2505
Notes: 1.
184
[Break on access error]
[Enable internal ROM area write]
[User VCC Threshold]
[Select P1VCC and P2VCC]
[User Signals]
[Driver]
[Change driver in start up]
2.
Environment for the H8S/2556 E6000 Emulator CPU 2000 Debugging Platform
[Mode] Option
The MCU previously selected
6 (advanced mode, on-chip ROM)
7 (advanced mode, single chip)
Target
Target in [Mode] is only available when the target system is connected.
Target and Target/2 in [Clock] are only available when the target system is connected.
When this box is checked, a break (the user program stops) occurs if
your program accesses an access-prohibited area or writes to a write-
protected area.
When this box is checked, writing to the internal ROM area is enabled.
For the result of writing, see the [Extended Monitor] window.
Sets the voltage level for the user system. [Down] will be displayed in
[User System Voltage ( P1Vcc, P2Vcc )] of the [Extended Monitor]
window when the actual user P1VCC or P2VCC of the target system is
lower than the specified value.
(When HS2556EPI61H is used, [Down] will be displayed in [User System
Voltage ( P1Vcc )] of the [Extended Monitor] window if the actual user
P1VCC of the target system is lower than the specified value.)
Selects the voltage of user P1VCC and user P2VCC ( 3V or 5V ). The
available range is 3.0 to 3.6V or 4.5 to 5.5V when 3V or 5V is selected,
respectively. (This option is only valid when HS2556EPI61H is used.)
the user system are enabled. Note that the standby signal is always
invalid because the hardware standby function is not supported.
However, the status of the signal can be checked in the [Extended
Monitor] window.
Displays the E6000 driver that is currently installed.
When this box is checked, selection of a driver will be available next time
the emulator is connected.
When this box is checked, the reset, NMI, and bus request signals from
Main: 10 MHz, Sub: 32 kHz
Main: 20 MHz, Sub: 32 kHz
Main: 10 MHz, Sub: Target
Main: 20 MHz, Sub: Target
Main: Target, Sub: Target
Main: Target/2, Sub: Target
Main: 10 MHz, Sub: 32 kHz
Main: 20 MHz, Sub: 32 kHz
Main: 26 MHz, Sub: 32 kHz
Main: 10 MHz, Sub: Target
Main: 20 MHz, Sub: Target
Main: 26 MHz, Sub: Target
Main: Target, Sub: Target
Main: Target/2, Sub: Target
[Clock] Option
Expansion
Hardware
None