UP2-DEVKIT/UNIV Altera, UP2-DEVKIT/UNIV Datasheet - Page 22

• Manufacturer Part Number: UP2-DEVKIT/UNIV
• Description: KIT DEVELOPMENT UNIVERSITY UP2
• Manufacturer: Altera
• Type: Education Kitr

Specifications of UP2-DEVKIT/UNIV

• Contents: Quartus®II Design Software, UP2 Dev. Board, Byteblaster Download Cable and Power Supply
• For Use With/related Products: Flex 10K® FPGAs
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 544-1293

University Program UP2 Education Kit User Guide
22
Configure/Program Both Devices
This section describes the procedures for configuring/programming both
the FLEX 10K and EPM7128S devices in a JTAG chain, (i.e., how to set the
on-board jumpers, connect the ByteBlaster II download cable, and set
options in the Quartus II software).
Setting the On-Board Jumpers for Configuring/Programming Both
Devices
To configure and program the FLEX 10K and EPM7128S devices in a
multi-device JTAG chain, set the jumpers TDI, TDO, DEVICE, and BOARD
as shown in Figure 9.
Figure 9. Jumper Settings for Configuring/Programming Both Devices
Connecting the ByteBlaster II Download Cable for Configuring &
Programming Both Devices
Attach the ByteBlaster II cable directly to the PC’s parallel port and to the
JTAG_IN connector on the UP2 Education Board.
For more information on setting up the ByteBlaster II cable, see the
ByteBlaster II Parallel Port Download Cable Data Sheet.
Setting the JTAG Options in the Quartus II Software for Configuring &
Programming Both Devices
The following steps describe how to use the Quartus II software to
configure and program both devices in a multi-device JTAG chain. For
more information on how to program or configure a device, see the
Quartus II Help.
1.
2.
Turn on the Multi-Device JTAG Chain command (JTAG menu).
Choose Multi-Device JTAG Chain Setup (JTAG menu).
TDI
C1
C2
C3
TDO
C1
C2
C3
DEVICE BOARD
C1
C2
C3
C1
C2
C3
Altera Corporation