ST92F150-EMU2 STMicroelectronics, ST92F150-EMU2 Datasheet - Page 20

• Manufacturer Part Number: ST92F150-EMU2
• Description: BOARD EMULATOR FOR ST9 SERIES
• Manufacturer: STMicroelectronics
• Series: ST9-EMU2r
• Type: Microcontrollerr

Specifications of ST92F150-EMU2

• Contents: ST9 Visual Debug IDE, ST9 HDS2V2 Mainboard, Probe, Sockets, Adapters, Power Supply,Cables & Documentation
• For Use With/related Products: ST9 MCUs
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 497-3101

3 - Configuring the Emulator
3.3
3.4
3.4.1
20/55
As delivered, AV
contacts have been connected with a thin copper wire. To remove contact on the
G1, scratch the thin copper wire between the two contacts of the solder point.
Configuring the P5.0 pin
You can choose to between configuring the P5.0 pin for use as a port or for use
with the WAITn function.
for each configuration
Mapping the memory space
Internal memories
The actual memories located inside an ST9+ chip (such as RAM, EEPROM and
FLASH) are called internal memories . When we say that we are using internal
memory, it means that we are in fact using the memory internal to the target ST9+
device located on the emulation probe. Doing this, however, greatly limits the
debugging functions that the emulator can perform, as described in the next
paragraph.
DD
W2
W2
is supplied from emulator probe—i.e. the G1 solder point
Figure 10: P5.0 pin configurations
Figure 10
W3
W3
below shows how to set jumpers W2 and W3
P5.0
I/O
WAITn
P5.0 used as I/O port
Jumper positions for
Jumper positions for
P5.0 used as WAIT
ST92F150-EMU2 User Manual