FS-9062 Digi International, FS-9062 Datasheet - Page 36

• Manufacturer Part Number: FS-9062
• Description: JTAG_BOOSTER FOR ANALOG DEVICES
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-9062

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: ADI, ADSP-BF531, 532, 533, 561
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

JTAG-Booster for Analog Devices Blackfin
/CFI
To be prepared for future flash chips, the JTAG-Booster integrates support for
flashes which contain the CFI (Common Flash Interface) information structure.
The CFI support is activated by simply adding the option /CFI to the command
line. The JTAG-Booster then automatically searches in all available bus widths
for all possible flash types and configurations after searching for the JEDEC
identification code.
In case of an error use the command line option /CFIDEBUG instead of /CFI
and redirect the program's output into a file. Sending us this file helps in
analyzing problems.
/8BIT /16BIT /32BIT
Specifies the data bus width to the target flash device. You can speed up
autodetection, if you specify the correct data bus size. You need this option
together with the option /DEVICE= to explicit specify a specific flash
configuration.
Note: Option
/32BIT
is not available for Analog Devices ADSP-
BF531/BF532/BF533.
/BYTE-MODE
If there is a flash device connected to the CPU which does have a byte mode pin
(8 bit and 16/32 bit bus mode), you can force it to be used as 8 bit mode with the
option /BYTE-MODE. In most cases this option will not be needed.
Abbreviation:
/BM
/NOMAN
If you use a flash device which is identical to one of the supported parts, but is
from a different manufacturer, with this option you can suppress the comparison
of the manufacturer identification code. We recommend to use this option
together with the /DEVICE= option to avoid failures in autodetection.
36
JTAG_ADSP-BLACKFINa.doc