FS-9062 Digi International, FS-9062 Datasheet - Page 35

• Manufacturer Part Number: FS-9062
• Description: JTAG_BOOSTER FOR ANALOG DEVICES
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-9062

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: ADI, ADSP-BF531, 532, 533, 561
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

JTAG-Booster for Analog Devices Blackfin
2.1.
Program a Flash Device
Usage:
JTBFxxx /P filename [optionlist]
The specified file is programmed into the flash memory. The flash status is polled
after programming of each cell (cell=8, 16 or 32 bit, depending on current data
bus width). In case of a programming error, the contents of the flash memory is
written to a file with the extension DMP.
If you want a complete verify after programming, please use an additional
command line with the verify function. See chapter 2.3 “Verify a Flash Device
with file”. In most cases this additional verify step is not needed.
The type of the flash device is normally detected by the software. When
autodetection fails you should use the /DEVICE= option together with /8BIT or
/16BIT or /32BIT to set the right flash device and configuration. The known flash
devices are shown in chapter 1.10 “Supported flash devices”. Use the option
/CFI if the flash is not in the list of known devices.
Options:
/DEVICE=devicename
The flash device is detected automatically by switching to autoselect mode. In
case of trouble you should select the flash device by using this parameter to
avoid autodetection. Combine this option with one of the following options which
specify the data bus width and the option /BYTE-MODE if applicable.
JTAG_ADSP-BLACKFINa.doc
35