HS2633REPI61H-U Renesas Electronics America, HS2633REPI61H-U Datasheet - Page 89

• Manufacturer Part Number: HS2633REPI61H-U
• Description: EMULATOR BASE UNIT H8S/2633R FAM
• Manufacturer: Renesas Electronics America
• Type: Microcontrollerr

Specifications of HS2633REPI61H-U

• Contents: E6000 Emulator and CD-ROM
• For Use With/related Products: H8S/2633R
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

[Probe1]:
(4) [Action] page
Use this page to decide what action the emulator takes when the defined event occurs.
[Action]:
[Delay after detection before break occurs]:
[High]:
[Low]:
[Don’t care]:
[Break]:
[Start Timer]:
[Stop Timer]:
Detects the status of the input probe signal 1
Figure 5.25 [Breakpoint/Event Properties] Dialog Box ([Action] Page)
Sets a 16-bit delay (in bus cycles) after the event has occurred before the action is
taken. The delay is only applicable to break events and there is only one delay counter
in hardware, therefore only one breakpoint can have a non-zero delay. The range of
values is D’0 to D’65,535 (only available when [Break] has been selected). This
cannot be used for an event point being used as the trace acquisition condition.
Detects the high level of the input probe signal
Detects the low level of the input probe signal
The status of the input probe signal is not detected
Selects an action that occurs when the event is satisfied. This cannot be used for an
event point being used as the trace acquisition condition.
Causes a break (stop) in the user program when the event occurs. This is the
default action.
Starts the run timer (the run timer value is displayed in the [Status] window).
Stops the run timer (the run timer value is displayed in the [Status] window).
69