HS3664EPI62H Renesas Electronics America, HS3664EPI62H Datasheet - Page 243

• Manufacturer Part Number: HS3664EPI62H
• Description: EMULATOR BASE UNIT H8/3664
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS3664EPI62H

• Contents: E6000 Emulator and CD-ROM
• For Use With/related Products: H8/3664
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

(10)
Table 8.52 Differences between the H8/36064 Group Products (1)
Target Address
H'FFE0
H'FFE1
H'FFE2
H'FFF1
H'FFF4
H'FFF5
H'FFF9
H'FFFA
Table 8.53 Differences between the H8/36064 Group Products (2)
Target Address
H’FFFB
Table 8.54 Differences between the H8/36064 Group Products (3)
Target Address
H’F730
H’F731
H’FF90
H’FF91
H’FF92
H’FF93
H’FF9B
Table 8.55 Differences between the H8/36064 Group Products (4)
Target Address
H’FFC0
(a) The description given in the hardware manual is “Initial value: 0. Reserved. These bits are always read as
(b) The description given in the hardware manual is “Reserved”. However, the description in the emulator
(c) The hardware manual shows registers at the addresses given below. For these locations, however, the
(d) Although the hardware manual says that an initial value is 1, the compact emulator’s initial value is “0”.
(e) Although the hardware manual says that the allowable output high current is 5.0 mA, it is 2.0 mA in the
manual is “Always specify 0. These bits are always read as the specified values”.
applicable description in the emulator manual is “Writing has no effect. These bits are always read as
undefined values”, because there are no registers at these locations of the emulator.
These bits must always be set to 1, when counting up the watchdog timer.
E6000 emulator.
0”. However, the description in the emulator manual is “Always specify 0. These bits are always read as
the specified values”.
Warnings that Apply to H8/36064 Group Programming
Register Name
Port mode register 1
Port mode register 5
Port mode register 3
System control register 2
Interrupt enable register 1
Interrupt enable register 2
Module standby control register 1
Module standby control register 2
Register Name
Low-voltage-detection control register
Low-voltage-detection status register
Flash memory control register 1
Flash memory control register 2
Flash memory power control register
Erase block register 1
Flash memory enable register
Register Name
Module Standby Control Register 3
Register Name
Timer Control/Status Register WD
Bits
0
7 and 6
7, 6, and 5
6
6
7 and 6
7, 2, and 0
6, 5, and 3
Bits
7 to 0
7 to 0
7 to 0
7 to 0
7 to 0
7 to 0
7 to 0
Bits
0
Bits
2
221