HS3664EPI62H Renesas Electronics America, HS3664EPI62H Datasheet - Page 231

• Manufacturer Part Number: HS3664EPI62H
• Description: EMULATOR BASE UNIT H8/3664
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS3664EPI62H

• Contents: E6000 Emulator and CD-ROM
• For Use With/related Products: H8/3664
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

(5) Warnings that Apply to H8/36014, H8/36024 Group Programming
Table 8.30 Differences between the H8/36014, H8/36024 Group Products (1)
Target Address
H'FFE0
H'FFF1
H'FFF2
H'FFF4
H'FFF9
H'FFFA
Table 8.31 Differences between the H8/36014, H8/36024 Group Products (2)
Target Address
H’FFE2
H’FFF5
H’FFFB
Table 8.32 Differences between the H8/36014, H8/36024 Group Products (3)
Target Address
H’F730
H’F731
(a) The description given in the hardware manual is “Initial value: 0. Reserved. These bits are always read as
(b) The description given in the hardware manual is “Reserved”. However, the description in the emulator
(c) The hardware manual shows registers at the addresses given below. For these locations, however, the
(d) The H8/36014, H8/36024 group has power-on reset and optional low-voltage detection circuit functions.
(e) While emulating the H8/36024 group, set PCR1 and PCR5 to ‘0’ if you want to use SCI3_3.
manual is “Always specify 0. These bits are always read as the specified values”.
applicable description in the emulator manual is “Writing has no effect. These bits are always read as
undefined values”, because there are no registers at these locations of the emulator.
However, the E6000 emulator does not support these functions.
0”. However, the description in the emulator manual is “Always specify 0. These bits are always read as
the specified values”.
Register Name
Port mode register 1
System control register 2
Interrupt edge select register 1
Interrupt enable register 1
Module standby control register 1
Module standby control register 2
Register Name
Low-voltage-detection control register
Low-voltage-detection status register
Register Name
Port mode register 3
Interrupt enable register 2
Module standby control register 3
Bits
6, 5, 2, and 0
6, 1, and 0
7, 2, and 1
6, 2, and 1
7 and 0
6 to 0
Bits
7 to 0
7 to 0
Bits
7 to 3
7 to 5
0
209