HS3664EPI62H Renesas Electronics America, HS3664EPI62H Datasheet - Page 240

• Manufacturer Part Number: HS3664EPI62H
• Description: EMULATOR BASE UNIT H8/3664
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS3664EPI62H

• Contents: E6000 Emulator and CD-ROM
• For Use With/related Products: H8/3664
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

(9) Warnings that Apply to H8/36902, H8/36912 Group Programming
Table 8.48 Differences between the H8/36902, H8/36912 Group Products (1)
Target Address
H'FFE0
H'FFE1
H'FFF1
H'FFF2
H'FFF3
H'FFF4
H'FFF5
H'FFF9
H'FFFA
Table 8.49 Differences between the H8/36902, H8/36912 Group Products (2)
Target Address
H’F730
H’F731
H’F734
H’F735
H’F736
H’F737
H’FFAE
Table 8.50 Differences between the H8/36902, H8/36912 Group Products (3)
Target Address
H’FFC0
218
(a) The description given in the hardware manual is “Initial value: 0. Reserved. These bits are always read as
(b) The hardware manual shows registers at the addresses given below. For these locations, however, the
(c) The H8/36902, H8/36912 group has power-on reset, low-voltage detection, on-chip oscillator and noise
(d) The initial value of WDON bit of Timer control/status register in H8/36902, H8/36912 group, is ‘1’ in the
applicable description in the emulator manual is “Writing has no effect. These bits are always read as
undefined values”, because there are no registers at these locations of the emulator.
filter of SCI. However, the E6000 emulator does not support these functions.
hardware manual. When using E6000, however, the initial value is ‘0’, and thus, please write ‘1’ when
you count up the watch dog timer.
0”. However, the description in the emulator manual is “Always specify 0. These bits are always read as
the specified values”.
Register Name
Port mode register 1
Port mode register 5
System control register 2
Interrupt edge select register 1
Interrupt edge select register 2
Interrupt enable register 1
Interrupt enable register 2
Module standby control register 1
Module standby control register 2
Register Name
Low-voltage-detection control register
Low-voltage-detection status register
Clock control/status register
RC control register
RC trimming data protect register
RC trimming data register
Sampling mode register
Register Name
Timer control/status register
Bits
6, 5, 3, 2, and 0
7, 6, 4 to 0
6, 1, and 0
7 ,2, and 1
4 to 0
6, 2, and 1
7 and 6
7 and 0
7 to 5, 3 to 0
Bits
7 to 0
7 to 0
7 to 0
7 to 0
7 to 0
7 to 0
7 to 0
Bits
2