M30800T-CPE Renesas Electronics America, M30800T-CPE Datasheet - Page 45

• Manufacturer Part Number: M30800T-CPE
• Description: EMULATOR COMPACT FOR M16C/80
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M30800T-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M16C/80
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

5.2 Troubleshooting When Using Emulator Debugger M3T-PD308M
When M3T-PD308M has started up normally, however, errors occurred while using it, remedy the
troubles referring Table 5.4.
Table 5.4 Error message and how to remedy it when using M3T-PD308M
Target clock is stopped
Target MCU is unable to reset.
Target MCU is reset state.
Please reset target systems.
Target MCU is HOLD state.
Target MCU is not given power.
Error message
Connection to the
( 43 / 52 )
Not connected
Not connected
Not connected
target system
Connected
Connected
Connected
Connected
Connected
- If an external clock is being supplied, check
the target system's oscillation circuit works
properly. Also, if using the sub-clock, see "3.4
Using the P8
(page 28).
- If the external clock supply is set, change to
internal supply. Also, if using the sub-clock,
see "3.4 Using the P8
Input" (page 28).
- If an external clock is being supplied, check
the target system's oscillation circuit works
properly. Also, if using the sub-clock, see "3.4
Using the P8
(page 28).
- If the external clock supply is set, change to
internal supply. Also, if using the sub-clock,
see "3.4 Using the P87/X
Input" (page 28).
- The target MCU has been reset. Cancel the
reset.
- If an external clock is being supplied, check
the target system's oscillation circuit works
properly. Also, if using the sub-clock, see "3.4
Using the P8
(page 28).
- The MCU may be in the stop or wait modes.
Either reset the MCU or cancel the mode with
an interrupt.
- If an external clock is being supplied, check
the target system's oscillation circuit works
properly. Also, if using the sub-clock, see "3.4
Using the P8
(page 28).
- The MCU may be in the stop or wait modes.
Either reset the MCU or cancel the mode with
an interrupt.
- Check the power supply and GND are properly
connected to the target system.
7
7
7
7
/X
/X
/X
/X
CIN
CIN
CIN
CIN
Checkpoint
Pin as Sub-Clock Input"
Pin as Sub-Clock Input"
Pin as Sub-Clock Input"
Pin as Sub-Clock Input"
7
/X
CIN
CIN
Pin as Sub-Clock
Pin as Sub-Clock