M30800T-CPE Renesas Electronics America, M30800T-CPE Datasheet - Page 24

• Manufacturer Part Number: M30800T-CPE
• Description: EMULATOR COMPACT FOR M16C/80
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M30800T-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M16C/80
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2.3 Emulator Initial Setup
Set the MCU power supply select jumper, MCU power voltage select jumper and the P8
switch of the emulator according to conditions of use.
Figure 2.4 Emulator initial setup
(1) MCU Power Supply/Voltage Select Jumpers
These are the jumper switches to select power supply to the MCU. As shown in Table 2.4 below, set
the switch according to the connection to the target system. Any settings not listed in Table 2.4 are
not allowed.
Table 2.4 Setting MCU power supply select jumper and MCU power voltage select jumper
(2) P8
This is the switch to select the function of P8
according to the usage of P8
Table 2.5 Setting P8
Not connected
Connection to
target system
Note on Setting Switches and Jumper Switches:
Connected
(2) MCU power supply select jumper (JP1)
(3) MCU power voltage select jumper (JP2)
(1) P8
Using as XCIN input
7
/X
Using as a port
7
/X
CIN
CIN
Usage
select switch (SW1)
Select Switch
• Always shut OFF when changing the setting of the switches and jumper switches,
and connecting the cable.
select jumper (JP1)
MCU power supply
7
/X
CIN
EXT
select switch
INT
7
/X
CIN
( 22 / 52 )
pin.
P8
CAUTION
MCU power voltage
select jumper (JP2)
7
(cannot be set)
/X
Set to "XCIN"
Set to "P87"
7
CIN
/X
Invalid
5.0 V
3.3 V
CIN
select switch
pin. As shown in Table 2.5 below, set the switch
Power of MCU is supplied from the
emulator. MCU operating voltage is 5.0 V
Do not set as this combination.
The operation is not be guaranteed.
Power of MCU is supplied from the
target system. This emulator consumes
max. 500 mA of electrical current from
the target system.
Description
7
/X
CIN
select