M30800T-CPE Renesas Electronics America, M30800T-CPE Datasheet - Page 23

• Manufacturer Part Number: M30800T-CPE
• Description: EMULATOR COMPACT FOR M16C/80
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M30800T-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M16C/80
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2.2 Starting Up the Emulator
The procedure for starting up the emulator is shown in Figure 2.3. For details, refer to each section
hereafter. And, when the emulator does not start up normally, refer to "Chapter 5. Troubleshooting"
(page 37).
Figure 2.3 Procedure for starting up the emulator
Select the MCU power supply select jumper.
Debug the program using M3T-PD308M.
Connect the power supply for emulator.
Specify the operating environment.
Connect the serial interface cable.
Start up the emulator debugger.
Set the P8
Check the LED of emulator.
Connect the target system.
Turn on the emulator.
7
/X
CIN
select switch.
( 21 / 52 )
Set the jumper according to the connection to the
target system.
* The MCU power voltage select jumper should be
Set the switch according to the usage of P8
Connect the serial interface cable to the serial
interface connector (J2) of emulator and the serial
port of the host machine.
Connect the power supply to the power connector
(J1). Specifications of emulator power are 5.0 V
±5%, 2 A.
Connect the target system to the LCC probe at the
bottom of emulator (when necessary).
Recheck the connection, and turn on the emulator.
When the target system is connected, turn on the
target system too. Turn them on as simultaneously
as possible.
Check "POWER" and "SAFE" of the system status
LEDs and "POWER" and "CLOCK" of the target
status LEDs light. When the target system is not
connected "POWER" does not light.
Start up the emulator debugger M3T-PD308M.
In the INIT dialog box of emulator debugger M3T-
PD308M, specify the following, and press the OK
button.
Emulator debugger M3T-PD308M offers various
debugging functions. For details on M3T-PD308M,
refer to the online manual of M3T-PD308M.
fixed to 5.0 V.
- MCU file: "M30800.MCU"
- Communication port: Select the serial port
- When not connected: INT
- When connected:
- For a port:
- For XCIN input: XCIN
where the emulator is connected.
P87
EXT
7
/X
CIN
pin.