HS0005KCU11H Renesas Electronics America, HS0005KCU11H Datasheet - Page 135

• Manufacturer Part Number: HS0005KCU11H
• Description: EMULATOR E10A-USB H8S(X),SH2(A)
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS0005KCU11H

• Contents: E10A-LITE, Cable and CD-ROM
• Core Architecture: H8S, H8SX And SH2
• Kit Contents: E10A-LITE, Cable And CD-ROM
• Features: H-UDI Interface, 14-Way Cable
• Tool / Board Applications: General Purpose MCU, MPU, DSP, DSC
• Core Sub-architecture: H8S, H8SX, SH2
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: H8S, H8SX, SH-2, SH-2A
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant

5.5.2
It is possible to specify the respective routines immediately before starting and immediately after
halting the user program execution.
When the [The specified routine is executed immediately before execution of the user’s program.]
check box is selected, the routine specified in the [starting address] combo box, which is below
this check box, is executed immediately before starting user program execution.
If no specified routine is executed immediately before starting user program execution, do not
select the [The specified routine is executed immediately before execution of the user’s program.]
check box.
When the [The specified routine is executed immediately after execution of the user’s program.]
check box is selected, the routine specified in the [starting address] combo box, which is below
this check box, is executed immediately after stopping user program execution.
If no specified routine is executed immediately before starting user program execution, do not
select the [The specified routine is executed immediately after execution of the user’s program.]
check box.
5.5.3
The start/stop function has the following restrictions.
• An RTS instruction must be written at the end of the user routine.
• The user routine must end.
• No break should occur within the user routine.
• No interrupt should be accepted in the user routine.
• The user routine to run immediately before the user program execution must end within 2
• The user routine to run after the user program execution is stopped must end within 30 sec.
• As the stack area for the routine specified for execution before the user program starts, use
•
• The specified routine is also executed when the following operations are performed:
• The user stack should be used by the routine specified for execution immediately after
⎯ Step operations
⎯ Watching or changing memory during user program execution. ∗
msec.
the firmware stack of the emulator. The stack area is no larger than H’80 bytes.
execution of the user program ends.
If the user routine is to use a general-purpose register, saving the contents of the register,
making the initial setting, and restoring the contents should all be done within the routine.
Restrictions on the Start/Stop Function
Specifying the Routine to be Executed
Rev. 12.00 Aug. 28, 2009 Page 115 of 188
Section 5 Debugging
REJ10J1140-1200