HS0005KCU01H Renesas Electronics America, HS0005KCU01H Datasheet - Page 7

• Manufacturer Part Number: HS0005KCU01H
• Description: ON CHIP DEBUG EMULATOR
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS0005KCU01H

• Contents: E10T-USB, Cable and CD-ROM
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: H8S, H8SX, SH-2, SH-2A, SH3, SH4, SH4A & SH-Mobile
• Lead Free Status / RoHS Status: Not Compliant, Contains lead / RoHS non-compliant

(1)
(2)
This manual describes the troubleshooting procedure that applies the test program for the E10A-USB
emulator.
1.1
installation, refer to section 3.4, Installing Emulator’s Software, in the Debugger Part of the SuperH™
Family E10A-USB Emulator User’s Manual.
To begin, make sure that the emulator software and USB driver are installed in the PC. For details on
The following equipments are required to execute the test program. Do not connect the user
system interface cable or the user system when executing the test program.
• E10A-USB emulator
• USB cable
• “E10A-USB emulator software” CD-R
• Host computer (hereafter referred to as the PC)
Start up the PC and connect the E10A-USB emulator to the USB connector of the PC with the
attached USB cable. Note that the user interface cable must be disconnected.
System Setup for Executing Test Program
Section 1 Test Program
Figure 1 Connection
Rev.3.00 Jun.10, 2009 Page 1 of 14
Section 1 Test Program
REJ10B0051-0300