DEMOKIT-LG2 Renesas Electronics America, DEMOKIT-LG2 Datasheet - Page 51

• Manufacturer Part Number: DEMOKIT-LG2
• Description: KIT DEMO 78K0 LG2 UPD78F0397
• Manufacturer: Renesas Electronics America

Specifications of DEMOKIT-LG2

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

DemoKit-LG2 User’s Manual
Table 12. Device Setup Box: Advance Properties
Group/Item
Command
options
Security flag
settings
Group/Item
Operation
Mode (some
modes not
available in
all devices)
Target Reset
Message
• Advance Properties: The Advance tab contains command options and security flag settings.
Option
Chip
Block
Area
Show Address
box
—
Option
Blank check
before Erase
Read verify
after Program
Security flag
after Program
Checksum
after Program
Disable Chip
Erase
Disable Block
Erase
Disable
Program
Figure 49. Device Setup Box: Advance Tab
Description
Performs a Blank Check before executing an Erase or Autoprocedure
(EPV) command. If the result of a blank check indicates OK, the Erase
command is not executed
Sends write data from the programmer after execution of the Program and
Autoprocedure (EPV) commands, and then verifies the data against the data
written to flash memory
Automatically programs the selected security flag after execution of the
Program and Autoprocedure (EPV) commands
Reads the flash memory checksum value of the target device after execution of
Program and Autoprocedure (EPV) commands; this value differs from the
value displayed in the Parameter Programming window
Invalidates the Erase command in the entire flash memory area of the target
device and displays a warning stating that When chip erase is disabled, chip
cannot be erased and programmed anymore!” Caution: If the security flag is
set in the target device, erasing and writing to the device cannot be enabled.
Invalidates the Erase command in all blocks of flash memory selected under
Operation Mode in the Standard tab of the Device Setup box; this setting is
cleared by the Erase command if chip is selected under Operation Mode
Invalidates the Program and Erase commands in all blocks of flash memory
selected under Operation Mode in the Standard tab of the Device Setup box.
The Erase command for the entire flash memory area is valid. This setting is
cleared by the Erase command if chip is selected for Operation Mode.
Description
Subjects the entire flash memory area of the target device to rewriting
Specifies a block of flash memory to be rewritten
Specifies an area to be rewritten. The Start/End list boxes display the Area
numbers where the flash memory of the target device is configured.
Specifies whether numbers or addresses are displayed in the Start/End boxes. If
selected, addresses are displayed. If not selected, numbers are displayed.
Displays the window promoting the manual reset operation, even when the
reset signal cannot be connected to the target cable.
45