101-0577 Rabbit Semiconductor, 101-0577 Datasheet - Page 96

• Manufacturer Part Number: 101-0577
• Description: KIT DEV FOR BL2500 COYOTE
• Manufacturer: Rabbit Semiconductor
• Series: Coyoter
• Type: Single Board Computers (SBC)r

Specifications of 101-0577

• Contents: SBC, Dev. Board, AC Adapter, Cable and Dynamic C® CD-ROM
• Product: Modules
• Data Bus Width: 10 bit
• Processor Type: Rabbit 3000
• Sram: 128 KB
• Flash: 256 KB
• Number Of I/os: 24
• Backup Battery: 3 V Lithium Coin Type
• Operating Voltage: 8 V to 40 V
• Power Consumption: 1 W
• Board Size: 100 mm x 100 mm x 29 mm
• Description/function: Computer Module
• Interface Type: Ethernet
• For Use With/related Products: BL2510
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

PARAMETERS
RETURN VALUE
SEE ALSO
PARAMETERS
RETURN VALUE
SEE ALSO
90
int rn_write(int handle, int regno, char *data,
int rn_read(int handle, int regno, char *recdata,
Writes a string to the specified device and register. Waits for results.
mation to determine that the peripheral card is connected to a master.
handle is an address index to device information. Use rn_device() or rn_find() to establish the
handle.
regno is the command register number as designated by each device.
data is a pointer to the address of the string to write to the device.
datalen is the number of bytes to write (0–15).
The status byte from the previous command. -1 means that device information indicates the peripheral
card is not connected to the master, and -2 means that the data length was greater than 15.
Reads a string from the specified device and register. Waits for results.
information to determine that the peripheral card is connected to a master.
handle is an address index to device information. Use rn_device() or rn_find() to establish the
handle.
regno is the command register number as designated by each device.
recdata is a pointer to the address of the string to read from the device.
datalen is the number of bytes to read (0–15).
The status byte from the previous command. -1 means that device information indicates the peripheral
card is not connected to the master, and -2 means that the data length was greater than 15.
int datalen);
int datalen);
rn_read
rn_write
NOTE: A data length of 0 will transmit the one-byte command register number.
NOTE: A data length of 0 will transmit the one-byte command register number.
This function will
This function will
check device infor-
Coyote (BL2500)
check device