DC-EM-KT Digi International, DC-EM-KT Datasheet - Page 94

• Manufacturer Part Number: DC-EM-KT
• Description: KIT INTEGRATION EM FOR S MODELS
• Manufacturer: Digi International
• Series: Digi Connect EM®r
• Type: MCU Moduler

Specifications of DC-EM-KT

• Contents: Module with plug-and-play firmware, Development Board, Documentation, CD, Cables and Power Supply
• For Use With/related Products: Digi Connect EM S Module
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 602-1003; DC-EM-01T-KT; DC-EM-02T-KT

9 4
C o n f i g u r a t i o n t h r o u g h t h e D e f a u l t W e b I n t e r f a c e
Alarm Conditions
To configure an alarm, click on it. The configuration page for individual alarms has two
sections:
Alarm Conditions
The Alarm Conditions part of the page is for specifying the conditions on which the alarm
is based. Alarm conditions include:
SNMP Trap: Indicates whether the alarm is sent as an SNMP trap.
–
–
–
Send To: The email address to which the alarm is sent.
Email Subject: The text to be included in the “Subject:” line of any alarms sent
as email messages.
Alarm Conditions: For specifying the conditions on which the alarm is based,
whether on GPIO pin state changes or serial data pattern matching.
Alarm Destinations: For specifying how the alarm is sent, either as an email
message or an SNMP trap, or both, and where the alarm is sent.
Send alarms based on GPIO pin states: Click this radio button to specify that
this alarm is sent when the specified GPIO pin states are detected. Then specify
the following:
–
–
–
If the SNMP Trap field is disabled, and the Send To field has a value, then the
alarm is sent as an email message only.
If the SNMP trap field is enabled and the Send To field is blank, then the alarm
is sent as an SNMP trap only.
If the SNMP Trap field is enabled, and a value is specified in the Send to field,
then that means the alarm is sent both as an email and as an SNMP trap.
Pins: An alarm is sent when the specified combination of pin states is detected.
High - pin is asserted.
Low - pin is not asserted.
Ιgnore - pin state is ignored.
Alarm recurrence time: Defines how often a new alarm can be sent. For
example, if the alarm recurrence time is 10 seconds then even if the pin states
are detected 5 times within a 10 second period only one alarm will be sent.
Send reminders while GPIO pins remain in this state: If enabled, reminders will
be sent if the pins remain in the defined state for an extended period of time.
D i g i C o n n e c t F a m i l y U s e r ’ s G u i d e