101-0530 Rabbit Semiconductor, 101-0530 Datasheet - Page 42

no-image

101-0530

Manufacturer Part Number
101-0530
Description
KIT TOOL FOR LP3500 INTL
Manufacturer
Rabbit Semiconductor
Series
RabbitCore 3000r
Type
Single Board Computers (SBC)r
Datasheet

Specifications of 101-0530

Contents
Demo Board, Serial Cable, Software and Documentation
For Use With/related Products
Rabbit 3000-based products, except RCM30/3100, LP3500
Lead Free Status / RoHS Status
Vendor undefined / Vendor undefined
A program “runs” in either mode, but can only be downloaded and debugged when the
LP3500 is in the Program Mode.
Refer to the
gramming port and the programming cable.
3.9.2 Standalone Operation of the LP3500
The LP3500 must be programmed via the Prototyping Board or via a similar arrangement
on a customer-supplied board. Once the LP3500 has been programmed successfully,
remove the serial programming cable from the programming connector and reset the
LP3500. The LP3500 may be reset by cycling the power off/on or by pressing the
button on the Prototyping Board. The LP3500 module may now be removed from the Pro-
totyping Board for end-use installation.
3.10 Other Hardware
3.10.1 Spectrum Spreader
The Rabbit 3000 features a spectrum spreader, which helps to mitigate EMI problems. By
default, the spectrum spreader is on automatically, but it may also be turned off or set to a
stronger setting. The means for doing so is through a simple global macro as shown below.
36
1. Select the “Defines” tab from the Dynamic C
2. Normal spreading is the default, and usually no entry is needed. If you need to specify
3. Click
normal spreading, add the line
For strong spreading, add the line
To disable the spectrum spreader, add the line
by the macro value whenever you are in the project file where you defined the macro.
ENABLE_SPREADER=1
ENABLE_SPREADER=2
ENABLE_SPREADER=0
CAUTION: Disconnect power to the Prototyping Board or other boards when removing
NOTE: Refer to the Rabbit 3000 Microprocessor User’s Manual for more information
NOTE: The strong spectrum-spreading setting is not recommended since it may limit
OK
or installing your LP3500 to protect against inadvertent shorts across the pins or dam-
age to the LP3500 if the pins are not plugged in correctly. Do not reapply power until
you have verified that the LP3500 is plugged in correctly.
on the spectrum-spreading setting and the maximum clock speed.
the maximum clock speed or the maximum baud rate. It is unlikely that the strong set-
ting will be used in a real application.
Rabbit 3000 Microprocessor User’s Manual
to save the macro. The spectrum spreader will now be set to the state specified
Options > Project Options
for more information on the pro-
Fox (LP3500)
menu.
RESET

Related parts for 101-0530