101-0530 Rabbit Semiconductor, 101-0530 Datasheet - Page 32

• Manufacturer Part Number: 101-0530
• Description: KIT TOOL FOR LP3500 INTL
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 3000r
• Type: Single Board Computers (SBC)r

Specifications of 101-0530

• Contents: Demo Board, Serial Cable, Software and Documentation
• For Use With/related Products: Rabbit 3000-based products, except RCM30/3100, LP3500
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined

3.4.1 RS-232
The LP3500 RS-232 serial communication is supported by an RS-232 transceiver. This trans-
ceiver provides the voltage output, slew rate, and input voltage immunity required to meet
the RS-232 serial communication protocol. Basically, the chip translates the Rabbit 3000’s
logic-level signals to RS-232 signal levels. Note that the polarity is reversed in an RS-232
circuit so that a +2.8 V output becomes approximately -7 V and 0 V is output as +7 V. The
RS-232 transceiver also provides the proper line loading for reliable communication.
RS-232 can be used effectively at the LP3500’s maximum baud rate for distances of up to
15 m.
Logic-level signals are also possible on Serial Ports B, C, and E by changing the 0 Ω
surface-mounted resistor jumper settings at locations JP1–JP6.
Serial Port E can be set to “listen” and “wake up” the LP3500 when the unit is in a low-
power mode.
3.4.2 RS-485
The LP3500 has one RS-485 serial channel, which is connected to Serial Port F on the
Rabbit 3000 through an RS-485 transceiver. The half-duplex communication uses the
Rabbit 3000’s PG0 pin to control the transmit enable on the communication line.
The RS-485 transceiver used on the LP3500 is only capable of supporting a maximum
baud rate of 64,000 bits/s.
The LP3500 can be used in an RS-485 multidrop network. Connect the 485+ to 485+ and
485– to 485– using single twisted-pair wires (nonstranded, tinned) as shown in Figure 13.
Note that a common ground is recommended.
26
Fox (LP3500)